User Manual

35
FINAL CHECKS AND CONNECTIONS
After the weather resistant case is installed, all cables run, and the radio,
control unit, speaker, and microphone installed, refer to the interconnection
diagrams and verify that all connections have been made and the equipment
is properly grounded. Make a final check of all cables to make sure they are
properly connected and dressed away from all moving parts and exhaust
pipes, and secured with cable ties. Then recheck all electrical connections
and radio mounting hardware.
HEADSET INSTALLATION (OPTION)
NOTE
To enable the PTT switch on the handlebar switch for
external headset options, the J
AGUAR
725M mobile radio
must be programmed so that INP2 is defined to be “PTT” or
“EXTPTT”. Without this software addition, the headset
options will not transmit.
The Headset Option includes the helmet-mounted noise canceling
microphone with single (or dual) speakers, the belt box assembly (with
internal amplifier), and the Helmet Kit Interface Cable.
1. Install the noise-canceling microphone and single (or dual) speakers in
the helmet per instructions provided by the vendor.
2. Remove the RIA plug 19B802554P26 from the option connector on the
back of the J
AGUAR
725M radio control unit. Connect the accessory
cable 19B802554P24 to the option connector.
3. Install the Helmet Kit Interface Cable (SM-MCH-71GT-2, etc.)
containing the PTT/CG disable switch to the left handlebar, insuring
that freedom of motion is not compromised. Route the eight pin
waterproof connector over to and mate it with the eight pin waterproof
connector that is part of accessory cable 19B802554P24.
4. Route the long end of the Helmet Kit Interface Cable containing the
four position quick disconnect plug along the bike and bring it out near
the location of the driver’s hip.