User's Manual

CONTROLS

This section describes the buttons, keys and rotary knobs used to control the

M7100

Series Mobile Scan and System Model radios. All functions and

controls of the Scan radio operate the same as the corresponding functions and

controls on the System radio. The Scan radio is equipped with a 4-button

keypad and the System radio is equipped with a 16-button keypad.

Many of the control buttons and keys have or can be programmed to have a

primary function and a secondary function. The SCAN button can be

programmed (as a secondary function) to toggle the keypad keys between

their primary function and their secondary function.

POWER ON-OFF VOLUME KNOB

This rotary knob applies power to the radio and adjusts the

receiver volume. Rotating the control clockwise out o

detent applies power to the radio. A single alert tone sounds

(if enabled through programming) to indicate the radio is

operational.

Rotating the control clockwise increases the volume level. Minimum volume

levels can be programmed into the radio to prevent missed calls due to a low

volume setting. While adjusting the volume, the display will briefly indicate

the volume level (i.e. VOL = 31). The volume range is from a minimum level

of zero (displayed as OFF in the display) up to 31, which is the loudest level.

SYSTEM/GROUP CHANNEL KNOB

This rotary knob selects the systems or groups/channels,

depending upon programming. This 16-

osition knob has no

stop or detent. See SYSTEM/GROUP/CHANNEL

SELECTION section for more details.

RAMP CONTROL

The primary function of this rocker type button is to scroll

through the System list or the Group/Channel list depending

upon programming. The secondary function is to increment o

decrement items within a list (phone list for example). Press

to scroll in increasing order and press

. to scroll in decreasing

order. To auto-ramp, press and hold the button.

SCAN ON/OFF

The primary function of this button is to toggle scan operation on

and OFF. When the radio is scanning, the SCAN LED is on and

all groups or channels in the scan list of the currently selected

systems are scanned.