User's Manual

30
After entering a selection mode, the following generic display format will
appear:
X X X X X X X X
Y Y Y = Z Z Z
Line 1 shows the currently selected item name (XXXXXXXX) from the list.
Line 2 indicates the list (YYY) that the selection is to be made from and the
number of the selected item (ZZZ) within the list. (In some cases the
information on lines 1 and 2 will be exchanged.) Enter the system selection
mode by pressing the
S key. If SYSTEM 2 is the current selection, the
display appears as follows:
S O U T H
S Y S = 2
Line 1 contains the current system name, SOUTH; and line 2, SYS = 2,
indicates that selection is from the system list and it is the second system
within the list.
A new system from the list is selected by using the RAMP control,
, or .,
or by directly entering the system number with the numeric keys. The RAMP
controls,
, or ., scroll through the list in increasing and decreasing order.
In the previous example, pressing the RAMP control
, selects the EAST
system as shown in the next display.
E A S T
S Y S = 3
The radio can be programmed to wrap around from one end of a list to the
other end or to stop at the ends.
DIRECT ACCESS
To directly access a selection, enter the corresponding number (e.g. 4)
followed by SEL to activate the selection. The entered number is displayed on
line 2 as shown below. Line 1 shows the current list being used for selection.
S E L S Y S
4
If a mistake is made while entering the number, press the DEL button to
backspace once and correct the entry. If an invalid number is entered, a short
low-pitched tone sounds when SEL is pressed.
To exit the selection mode, press the
c button or wait for the time-out. If
the selection mode is cleared while an entry is pending (i.e., numbers are