User's Manual

37
Table 4 – Available Feature Numbers
BIT FIELDS POSSIBLE FEATURES
01 Conventional mode Priority Scan
02 EDACS 3 Site System Scan
03 Public Address operation
04 EDACS Group Scan operation
05 EDACS Priority System Scan
06 ProSound™/ProScan™
07 EDACS Dynamic Regroup operation
08 EDACS Emergency Operation
09 Type 99 Encode
10 Conventional mode Emergency operation
11 Not Supported
12 Aegis™ Digital Voice operation
13 VGE encryption
14 DES encryption
15 User-defined speech encryption
16 Mobile Data operation
17 Status and Message operation
18 Test Unit Operation
21 Alternate Language Operation
22 Over The Air Personality Programming (ProFile™)
23 Not Supported
29 ProVoice™ Operation
SYSTEM/GROUP/CHANNEL SELECTION
In the following description of SYSTEM/GROUP/CHANNEL
SELECTION, the term group is used for both group and channel.
The M7100
IP
SYSTEM/GROUP/CHANNEL knob and the RAMP controls,
, and ., are programmable for maximum flexibility. If the
SYSTEM/GROUP/CHANNEL knob is assigned to select groups, then the
RAMP controls,
, and ., are assigned to select systems. If the
SYSTEM/GROUP/CHANNEL knob is assigned to select systems, then the
RAMP controls,
, and ., are assigned to select groups. System, group,
and channel selection is the primary function for these controls.
Either systems or groups can also be selected by entering the select mode and
following the selection mode rules described earlier. The system select or
group select modes are entered by pressing SYS or GRP, respectively, from
the standard receive mode. Using the RAMP controls,
, or ., after
entering a particular selection mode in this manner is the secondary function
of these keys.