User's Manual

Menu Selection

Press M and then use the RAMP controls, , and ., to scroll through the

selections until SYS SCAN is displayed. Then press

M to toggle the

System Scan state. The SYSC ON or SYSC OFF display message is

displayed for two seconds to show the new state.

Pre-Programmed Keypad Key

Press the pre-programmed key and the SYSC ON or SYSC OFF display

message is displayed for two seconds to show the new state.

GROUP SCAN OPERATION

Only Groups that are part of the radio's scan list will be scanned. Groups are

added to the scan list on a per system basis through programming, the radio

keypad, or both, dependent upon programming. This scan list can be changed

by the user from the keypad unless programmed otherwise. Each system's

group scan list is retained in memory when the radio is turned off. The

M7100

Series mobile radio can also be programmed to provide Trunked

Priority Group Scan capability, which operates similar to priority scan in

Conventional mode.

The following is a description of programmable scan features that should be

helpful in understanding the Group Scan Operation of the radio:

Scan Hang Time - the delay time the radio waits before resuming scan after

the push-to-talk is released or after the carrier has dropped a channel.

TX Select - the group the radio will transmit on while scanning. The radio is

programmed to transmit on either the scanned group or the selected group.

Scan List (privileges) - this feature allows or prohibits scan list changes by the

user.

P1 Programming - priority group programming is accomplished by one (and

only one) of three methods:

1. From the keypad, where the Priority programming is not fixed and

does not follow the selected channel,

2. Priority 1 group programming follows the selected channel, or

3. Priority 1 group programming is fixed during PC Programming and

cannot be changed by the user.

P1 Always Scan - determines if the Priority 1 Group will always be scanned,

regardless of the scan state set by the user.

Adding Groups to a Scan List

1. With scan operation turned off, select the desired group to add to the

selected Trunked system group scan list.