User's Manual

2. Press

< or > on the SCAN add/delete control. The current priority

status of the group will be displayed in column 1 of line 1 for a time-out

period. If the group is not part of the scan list the status will be blank.

3. While the status is displayed press

< to add the group to the scan list.

"S" is displayed on line 1.

4. Press

< a second time to set the group to Priority 2. A "2" is displayed

on line 1.

5. Press

< a third time to set the group to Priority 1. A "1" is displayed on

line 1. The priority level selection sequence only advances the group to

next higher priority level and stops at priority level 1. To select a lower

priority level, the group must be deleted from the scan list and then added

back to the scan list. Each new group added to the scan list starts at the

lowest priority. If the Priority 1 and Priority 2 groups are already set and

a new group is assigned as Priority 1 or Priority 2, the previously assigned

group will change to non-priority scanning.

Deleting Groups from a Scan List

1. With scan operation turned off, select the desired group to delete from the

selected trunked system's group scan list.

2. Press

< or > on the SCAN add/delete control. The current status of the

group is displayed for a time-out period.

3. Press

> to delete the group from the scan list. "S", "2" or "1" turns off.

Any group that is not in a trunked system group scan list will show a

"blank" for the time period when it is the selected channel.

Nuisance Delete

A group can also be deleted from the scan list, if it is not the currently selected

group, by pressing > during scan operation while the radio is displaying the

unwanted group. The group will be deleted from the system's group scan list

in the same manner as if done using the steps above. Deletions done in this

manner will not remain deleted if the radio is turned off and then back on.

Turning Scan On

1. Toggle scan operation by pressing k. The SCAN indicator will turn on

when the radio is scanning.

NOTE

The k key light will blink when temporarily disabled.

Scanning will stop while microphone is off-hook if the

hookswitch feature is enabled through programming.