User's Manual

The saved call list shows all ten storage locations. if no calls have been

received, the saved call list will be empty and the pre-stored list will be

available upon entering the individual call mode.

When in the saved call list, pressing

m toggles the time stamp on and OFF.

The time stamp indicates how long ago the call was received. The display

indicates this information as HH:MM:SS where HH = hours, MM = minutes

and SS = seconds.

When in the pre-stored list, pressing

m toggles the Logical IDentification

(LID) on and OFF.

Sending An Individual Call

The following procedures describe how to initiate and complete an individual

call.

1. To select a previously stored individual, select the I-Call mode from the

menu or press

i followed by the RAMP control , or . to scroll

through the list of stored individuals. The selection mode rules apply.

While in the individual call list, the menu key will toggle the display

between the call name and the unit ID number. If the individual is not

stored in this list but the individual's unit ID is known, it can be entered

directly from the keypad.

2. Press the PTT button; the radio performs the necessary signaling to obtain

a communication channel. When the signaling is complete and the radio is

clear to transmit, TX indicator turns ON and the channel access tone

sounds. Line 1 shows the called individual's name if found in the list of

stored individuals or ID followed by the logical ID number of the unit

being called. The message *INDV* displays on line 2. Proceed with the

message.