User's Manual

59
for priority-two scanning and 2 is displayed on line 1. An additional press
of
< sets the channel for priority-one scanning and 1 is displayed on line
1. If the priority-one or priority-two channels are already set and a new
channel is then assigned as the priority-one or priority-two channel, the
previously assigned priority channel will change to non-priority scanning.
The priority setting selection sequence is set and stops at priority-one
therefore the channel must be deleted from the scan list by pressing
>
before the channel is set to a previous priority setting. Any channel that is
in a system's channel scan list will show S, 2, or 1 for the time-out period
when it is the selected channel.
Deleting Channels From A Scan List
1. With scan operation turned OFF select the desired channel to delete from
the selected conventional system's channel scan list.
2. Press
< or > on the SCAN add/delete control. The current status is
displayed for a time-out period. Press
> to delete the channel from the
scan list. S, 2, or 1 will turn OFF. Any channel that is not in a
conventional system channel scan list will show a "blank" for the time-
out period when it is the selected channel.
Nuisance Delete
A channel can also be deleted from the scan list, if it is not the currently
selected channel, by pressing
> during scan operation while the radio is
displaying the unwanted channel. The channel will be deleted from the
conventional system's channel scan list in the same manner as if done using
the steps above. Deletions done in this manner will not remain deleted if the
radio is turned OFF and then back ON.
TURNING SCAN ON
1. Toggle the scan operation ON by pressing k. The SCAN indicator will
turn ON when the radio is scanning.
NOTE
Scanning will stop while the microphone is OFF-hook if the
hookswitch feature is enabled through programming.
2. When a channel on the scan list receives a channel assignment, the radio
unmutes on the assigned channel, BSY indicator comes ON and the
received scan channel is displayed.
• The radio will continue scanning if a new channel is selected when
scan is ON.
• Pressing the PTT button when scan is ON will cause the radio to
transmit on the displayed channel or to the currently selected channel