User's Manual

depending on programming.

• Pressing

< when scan is ON will cause the radio to recall the

scanned channel that was last received. This channel is recalled for a

period equal to the scan hang time.

TURNING SCAN OFF

Toggle the scan operation OFF by pressing k. The radio will resume

operation on the selected channel.

SQUELCH ADJUST

In the conventional mode of operation, the squelch can be re-adjusted in the

MENU selection mode or from a front panel key on the keypad that has been

pre-programmed using ProGrammer™ software. A default value of 9, or any

user level between 1 and 16, can be selected using ProGrammer software.

The user can change this setting either of two ways from the front panel keys.

NOTE

A value of 16 requires a strong signal to open squelch, a

value of 2 requires a very weak signal to open squelch, and

a value of 1 is open squelch.

NOTE

When the squelch adjust feature is activated, Channel

Guard, T99 decode, and Scan are disabled. When the

squelch adjust feature is exited, Channel Guard, T99

decode, and Scan are restored to their previous states.

Menu Selection

1. Press the m key and then use the RAMP control , or . to scroll

through the selections until SQUELCH is displayed. Then press

(SELECT) again.

2. The display will show SQLCH=xx, where "xx" is the value between 1

and 16.

3. Use the RAMP control

, or . to scroll through the values. Then press

the

m (SELECT) key to save the new value after the display time-out (2

seconds). The displayed value will be selected and saved.

4. If the

m or c key is pressed before the time-out, the menu feature will

exit and the squelch level will not be updated. The original value will be

restored.