User's Manual

Muting a Specified Radio

Pressing the control unit mute button associated with a particular radio will

mute its audio for a pre-programmed time period. The time period can be

cleared by pressing the control unit mute button or the radio selection button.

Multiple Radio and Siren & Light Operation

For siren and lights to function correctly, both the master and slave radios

must be programmed with the same siren and light information.

Multiple Radio and Data Operation

Only the master radio supports mobile data operation.

LAST SYSTEM/GROUP/CHANNEL RECALL

This feature, available for Master units only, enables the user to recall the last

selected system/group after an EDACS emergency or home function, a

conventional emergency or home function or system/group key function. This

feature must be enabled through ProGrammer to function. For example, if the

Home button (pre-programmed) is pressed, the radio will go to the designated

Home system/group or channel. If the Home button is pressed again, the radio

returns to the previous system/group or channel. At this time, the user can

toggle between the Home system/group or channel and the previous

system/group or channel. The operation is the same for the SG1-SG5 buttons.

MACRO KEY OPERATION

Macro key operation permits the user to accomplish a series of keystrokes

with a single "macro" keystroke. Up to ten (10) macro keys can be defined,

each capable of executing up to twenty (20) keystrokes, to any pushbutton

input (i.e., keypad keys, buttons, etc.). Each macro key can be pre-

programmed to activate when pressed or when released.

A macro key can also be pre-programmed to change the keystroke sequence

the next time the macro key is activated.

For detail operation and assignment of macro keys, contact your

communications supervisor or administrator.

INTERCONNECT CALL (SYSTEM MODEL ONLY)

To send a manually entered telephone interconnect call:

1. Select a channel in the radio system that has telephone interconnect

capability. The radio should be programmed for DTMF operation on this

channel.

2. Press the

k button to toggle the keypad to the DTMF function

(secondary function).