User Manual

MODULE DESCRIPTIONS
LBI-38812K 9
3.0 MODULE DESCRIPTIONS
The following descriptions for each interface module give the application and a reference
to the applicable instruction manual:
19C852204G1 Interface Module - This is a general-purpose interface module that
connects four wires from each of ten six-pin modular connectors (for inside connections)
to two fifty-pin Telco connectors (for outside connections). See LBI-38813.
19C852213G1 Power Monitor Module - This module provides the connection points
for transmitter and antenna power sensor circuits at the Site Controller cabinet when
using the old DB8843-based Power Monitor Unit. (See the 19C852632G1 Power Sensor
Interface Module when using the new DB8860-based Power Monitor Unit.) See LBI-
38815.
19C852215G1 PTT Module - This module is used as a connection point and cross
connect for the PTT and Analog/Digital signaling circuits between the microwave link
and the station transmitters at a Remote Transmit Site in a Simulcast system. See LBI-
38816.
19C852218G1 EDACS Interface Power Monitor Module for Simulcast - This
module provides the connection points for transmitter and antenna power sensor circuits
at a Simulcast site. See LBI-38819.
19C852226G1 EDACS CTIS Module - This module is used to collect and route
telephone interface analog/data for the Central Telephone Interconnect System (CTIS).
See LBI-38818.
19C852313G1 EDACS Interface VAX Site Controller - This module provides the
connection points for the GETC Data circuits in the EDACS Interface Panel for the VAX
Site Controller. See LBI-38943.
19C852323G1 EDACS Interface Serial Module - This module provides the connection
points for the Failsoft and RIC data links. This module has been replaced by the
19C852447G1 module which adds connection points for GETC reset and status lines
(used by Guardog). See LBI-38930.
19C852327G1 Euro EDACS Interface Board - This is a general-purpose interface
module that provides inside connection points for six 8-pin modular connectors. See
LBI-38946.
19C852339G1 TUAI for Simulcast - This module replaces the earlier 19C852219G1
TUAI Module, and provides alarm connection points for up to 25 TUAI channels and up
to four Test Units. See LBI-38948.
19C852349G1 EDACS Interface RIC Transformer Signal In/Out Isolation - This
module provides isolation transformers for eight telephone circuits. See LBI-38947.
19C852379G1 EDACS Interface Power Monitor / Channel Select Module - This
plug-in board provides grounding jumpers for the power sensor circuits connected to a
Power Monitor Unit. This board is used with the 19C852632G1 Power Sensor Interface
Module used with the new DB8860-based Power Monitor Unit. See LBI-38944.
19C852427G1 EDACS Interface Simulcast 150-Baud Interface Module - This
module is used to re-map jackfield appearances of 150-Baud data. See LBI-38945.