User's Manual

MM-015039-001, Rev. H
8
1.6 REGULATORY APPROVALS
1.6.1 Federal Communications Commission
The transmitting device described within this manual has been tested and found to meet the following
regulatory requirements:
FCC FILING DATA FOR MASTR V BASE STATION
FREQUENCY BAND
(MHz)
POWER OUTPUT
(ADJUSTABLE)
(Watts)
FCC TYPE
ACCEPTANCE NUMBER
APPLICABLE
FCC RULES
150.0125 – 173.9875
10 – 100
1
OWDTR-0065-E
Parts 22, 80, 90
420 – 430
10 – 100
OWDTR-0129-E
Part 90
450 – 470
10 – 100
OWDTR-0130-E
Part 22, 80, 90
470.00625 – 493.99375
10 – 100
OWDTR-0100-E
Part 90
494.00625 – 511.99375
10 – 100
OWDTR-0101-E
Part 90
764 – 776
10 – 100
OWDTR-0057-E
Part 90
851 – 869
10 – 100
OWDTR-0053-E
Part 90
This receiver associated with this transmitting device has been tested and declared to meet the regulatory
requirements defined in the following sub-sections. Associated FCC labeling may be found on page 2.
1.6.1.1 FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and,
2. This device must accept any interference received, including interference that may cause undesired
operation.
1.6.1.2 Information to the User
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment does generate, use, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an AC outlet on a circuit different from that which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
1
100 Watts is the RF output power as measured at the transmitter High Power Amplifier output connector. For equipment
operating in accordance with FCC rules 47CFR80, it is the responsibility of the licensee to ensure the station is installed
and aligned for a maximum of 50 Watts forward RF power as measured at the base of the antenna.