Installation Manual
Table Of Contents
- 1. REGULATORY AND SAFETY INFORMATION
- 1.1 SAFETY SYMBOL CONVENTIONS
- 1.2 RF ENERGY EXPOSURE AWARENESS AND CONTROL INFORMATION FOR FCC OCCUPATIONAL USE REQUIREMENTS
- 1.3 Federal Communications Commission Regulations
- 1.4 COMPLIANCE WITH RF EXPOSURE STANDARDS
- 1.5 REGULATORY APPROVALS
- 1.6 OCCUPATIONAL SAFETY GUIDELINES AND SAFETY TRAINING INFORMATION
- 1.7 COMMON HAZARDS
- 1.8 SAFE DRIVING RECOMMENDATIONS
- 1.9 OPERATING RULES AND REGULATIONS
- 1.10 OPERATING TIPS
- 2. RENSEIGNEMENTS SUR LA RÉGLEMENTATION ET SÉCURITÉ
- 3. SPECIFICATIONS0F
- 4. OPTIONS AND ACCESSORIES
- 5. INTRODUCTION
- 6. INSTALLATION PROCESS
- 6.1 GENERAL INFORMATION
- 6.2 PRE-INSTALLATION VEHICLE CHECK
- 6.3 PLANNING THE INSTALLATION
- 6.4 WIRING and CABLING REQUIREMENTS
- 6.5 TOOLS REQUIRED
- 6.6 UNPACKING AND CHECKING THE EQUIPMENT
- 7. ANTENNA INSTALLATION
- 7.1 ANTENNA MOUNTING LOCATIONS
- 7.2 RF ANTENNA INSTALLATION PROCEDURES
- 7.2.1 Installing Antenna Mounts AN-125001-002, -004, and -006
- 7.2.2 Installing Magnetic Antenna Mount AN-125001-008 and 12099-0370-01
- 7.2.3 Installing All Other Antenna Mounts
- 7.2.4 Attaching the NMO Antenna Element
- 7.2.5 Installing the Coax Cable and TNC RF Connector
- 7.2.6 Install GPS Antenna (If Required)
- 7.2.7 Installing a GPS Combo Antenna
- 7.2.8 Installing a GPS Antenna Inside the Rear-Deck
- 8. FRONT-MOUNT RADIO INSTALLATION
- 9. REMOTE-MOUNT RADIO INSTALLATION
- 9.1 MOUNTING THE REMOTE-MOUNT RADIO
- 9.2 REMOTE-MOUNT RADIO’S WIRING AND CABLING
- 9.3 CONTROL HEAD INSTALLATION
- 10. OPTION AND ACCESSORY INSTALLATION
- 11. CABLES AND CONNECTIONS
- 12. INSTALLATION INSPECTION AND TESTS
- 13. CARING FOR THE RADIO EQUIPMENT
- 14. CUSTOMER SERVICE
- 15. INSTALLATION CHECKLIST
- 16. WARRANTY REGISTRATION
14221-1850-4000, Rev. A
12
• Interference To Vehicular Electronic Systems - Electronic fuel injection systems, electronic anti-
skid braking systems, electronic cruise control systems, etc., are typical of the types of electronic
devices that can malfunction due to the lack of protection from radio frequency (RF) energy present
when transmitting. If the vehicle contains such equipment, consult the dealer for the make of vehicle
and enlist his aid in determining if such electronic circuits perform normally when the radio is
transmitting.
• Electric Blasting Caps - To prevent accidental detonation of electric blasting caps, DO NOT use two-
way radios within 1000 feet (305 meters) of blasting operations. Always obey the “Turn Off Two-
Way Radios” (or equivalent) signs posted where electric blasting caps are being used. (OSHA
Standard: 1926.900).
• Radio Frequency Energy - To prevent burns or related physical injury from radio frequency energy,
do not operate the transmitter when anyone outside of the vehicle is within the minimum safe distance
from the antenna as specified in Table 1-1. Refer to Section 1.2 for additional information.
• Vehicles Powered by Liquefied Petroleum (LP) Gas - Radio installation in vehicles powered by
liquefied petroleum gas, where the LP gas container is in the trunk or other sealed-off space within the
interior of the vehicle, must conform to the National Fire Protection Association standard NFPA 58.
This requires:
Ø The space containing the radio equipment must be isolated by a seal from the space containing
the LP gas container and its fittings.
Ø Outside filling connections must be used for the LP gas container.
Ø The LP gas container space shall be vented to the outside of the vehicle.
• Vehicles Equipped with Airbags - For driver and passenger safety, avoid mounting the radio’s Control
Head (or any other component) above or near airbag deployment areas. In addition to driver-side and
passenger-side front-impact airbags, some vehicles may also be equipped with side-impact airbags. For
occupant safety, verify the location of all airbags within the vehicle before installing the radio
equipment.
1.8 SAFE DRIVING RECOMMENDATIONS
The American Automobile Association (AAA) advocates the following key safe driving recommendations:
• Read the literature on the safe operation of the radio.
• Keep both hands on the steering wheel and the microphone in its hanger whenever the vehicle is in motion.
• Place calls only when the vehicle is stopped.
• When talking from a moving vehicle is unavoidable, drive in the slower lane. Keep conversations brief.
• If a conversation requires taking notes or complex thought, stop the vehicle in a safe place and continue
the call.
• Whenever using a mobile radio, exercise caution.
1.9 OPERATING RULES AND REGULATIONS
Two-way radio systems must be operated in accordance with the rules and regulations of the local, regional,
or national government.
In the United States, the XL Mobile radio must be operated in accordance with the rules and regulations of
the Federal Communications Commission (FCC). Operators of two-way radio equipment must be
thoroughly familiar with the rules that apply to the radio operation. Following these rules helps eliminate