TDS

TECHNICAL DATA SHEET
Titanium Satin (TT-1214)
2 in 1: Primer & Paint
Description
Harris® Titanium Satin is an extreme
duty high quality 100% acrylic
interior/exterior satin paint for masonry,
stucco, wood, metal, drywall and brick.
We have used the latest advances of
modern chemical technology and quality
control to achieve the finest paint your
money can buy. Titanium Satin is a low
odor and low VOC paint. One coat
gives all the desirable characteristics
of a fine quality paint. It dries in 1
hour and presents an extremely
durable film that resists
yellowing, chipping, cracking and
peeling. May be applied with brush, roller or
sprayer.
Product Advantages
• Spatter Resistant
• Low Odor
• Durable and tough
• Mildew and stain res
i
s
tant
• W
ill not peel or blister under extreme
c
on
d
i
tions
• Ea
sy to clean
• Excellent color retention with lightfast
colorants
• E
xcellent coverage
• Chalk resistant
For industrial, commercial and
residential use on new or previously
painted drywall, masonry, brick,
concrete and properly prepared wood
and metal.
Follow tinting requirement specified
within appropriate color formula book, color
matching computer
and automatic tinting
equipment.
BASE/COLOR:
White/Pastel
Deep
Accent
The use of deep tinted colors or high
contrast accent colors may require the
addition of one or more finish to achieve
acceptable coverage and hiding results.
Technical Data
53.6 ± 1% by weight
38.7
± 1% by volume
47 g/L
SOLIDS:
V.O.C LEVEL:
WEIGHT / GALLON:
11.00 ± 0.5 lbs.
FINISH: Satin (12-20%)*Geometry 60º
FLASH POINT: Non-flammable
FIRE RATING: Class A
VISCOSITY: 100-110 Ku’s
SUG
GESTED FILM THICKNESS,
COVERAGE PER COAT:
4.0 mils wet, 1.5 mils dry
400 sq ft/ ga
*Cover
age figures do not include
surface porosity, irregularities & material
loss due to application methods.
Application
Stir or shake thoroughly before using.
Read all label and Safety Data Sheets
(S.D.S.) information prior to use. Paint
always on shaded side of the building.
Do not apply in cold, damp conditions.
Avoid exterior application late in the
day when dew or condensation is
likely to form or rain is expected.
Typical standard practice recommends
intermixing when working with more
than one container of a tinted color, to
ensure color consistency.
BRUSH: Use a high quality nylon
or polyester brush.
ROLLER: Use a ¼” to 1 ¼” nap roller
cover,
depending on the substrate
texture.
AIRLESS SPRAY: Use a tip size from .017”
to .023”. Spray application must be back
rolled to work material into surface.
MIXING: Always mix thoroughly before
and during application.
THINNING: This product is not to
be
thinned.
CLEANUP:
Cle
an all equipment
immediately after use with warm
soapy water. Completely flush all
spray equipment with this solution
DRYING TIME@ 77
O
F @ 50% RH:
Temperature and humidity
dependent.
To touch: 1 hour To recoat: 4 hours
Technical Compliance:
AIM: PASSES
OTC: PASSES
Base & Tinting Information
Product Uses
Visit harrispaints.com &