User Manual

MM-018965-001

1 REGULATORY AND SAFETY INFORMATION

1.1 REGULATORY APPROVALS

1.1.1 Transmitter

The transmitting devices listed below have been tested and meet the following regulatory requirements:

MODEL DESCRIPTION

(MHz)

FCC ID

(PART 90)

INDUSTRY

CANADA

(RSS-119)

VM-WM4900-CL001 Broadband Client 5 or 10 BV8WM4900CL 3670A-WM4900CL

1.1.2 Receiver

This receiver associated with this transmitting device has been tested and declared to meet the regulatory

requirements defined in the following sub-sections. Associated FCC labelling may be found on page 2.

1.1.3 FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device

does not cause harmful interference.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

1.1.4 Industry Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

WARNING

The installer of this radio equipment must ensure that the antenna is located or

pointed such that it does not emit RF field in excess of Health Canada limits for the

general population; consult Safety Code 6, obtainable from Heath Canada’s website

www.hc-sc.gc.ca/rpb.

1.2 SAFETY SYMBOL CONVENTIONS

The following conventions may be used in this manual to alert the user to general safety precautions that

must be observed during all phases of operation, service, and repair of this product. Failure to comply