Install Instructions

6
Model TLC
All-Fuel Chimney - 5" to 8" Installation Instructions
Hart & Cooley, Inc.
Place the required offset chimney length(s) as per the
Offset Chimney Installation chart for appropriate
length(s). Turn it clockwise to lock it in place and fasten
in place with the supplied locking band.
Install the remaining offset elbow to turn the chimney
back to the vertical position and fasten in place with the
supplied locking band.
During installation, provide supplementary support for the
offset section to avoid undue stress on connected elbows.
Install an elbow support just above the highest elbow.
Attach the support band to the chimney with four of the
nuts and bolts, and then install the four stainless steel
sheet metal screws through the prepunched holes. Attach
the support straps to the support band assembly, and nail
the support straps to the framing using 6d 2" nails or
#8 x 1½" wood screws. See Figure 8.
Never install an elbow in a joist area. Chimney sections must
pass vertically through framed joist areas.
Note: Never offset an exterior chimney.
Adjustable Wall Support Installation
As previously mentioned, the ideal location for your
chimney system is within the building envelope. A wall
support installation is required when the above-mentioned
location is not possible.
To complete a proper wall support installation, the
following parts will or may be required.
•
W
all Support: Intended for a through-the-wall
installation where the chimney has a horizontal
connection.
•
S
tovepipe Adapter: Transition from chimney to flue pipe.
•
Insulated Tee with Insulated T
ee Cap: Allowing a
horizontal connection to the chimney.
•
Roof Flashing
Assembly: Required when the chimney
penetrates a roof or a roof overhang.
•
Raf
ter Radiation Shield
: Required when the chimney is
enclosed immediately below the roof.
•
W
all Band: Required to provide lateral support to chimney.
•
Suit
able Lengths of Chimney: The chimney diameter
should be sized to suit the appliance.
•
Chimney Length: Appropriate length for connection to
tee branch.
•
W
all Thimble: Required to pass though a combustible
wall. It also acts as a firestop.
•
Rain Cap
: Deluxe model.
Note: Never offset an exterior chimney.