Datasheet

03
.
04
RJ Industrial
1 2 3
6 5 4
7 8 9
12 11 10
6 Place the data module and the splicing piece into
the supplied IDC assembly tool
7 Press the data module and the IDC assembly tool
together, to make the insulation displacement
contact
8 Remove the assembled data module from the
IDC assembly tool
9 Put on the upper shield plate, and push it over the
cable shield
10 Put the lower shield plate in place, and latch it
to the upper shield plate with an audible
click
11 Push the housing over the assembled data
module, latching it into place with an audible click
12 Tighten the cable gland
Assembly operations
HARTING RJ Industrial
®
IP 20 Data
Only a few steps are necessary to quickly and reliably
connect an Industrial Ethernet cable to a HARTING
RJ Industrial
®
connector with IDC connection
technology.
1 Push the housing complete with cable gland over
the outer insulation of the cable
2 Strip the correct length of outer insulation and
shielding braid
3 Prepare the cores to match the splicing piece in
accordance with the colour code
4 Insert the cores into the splicing piece to the
required depth
5 Place the splicing piece on the RJ 45 data
module and engage it
General information
Connectors