User Manual

8
TROUBLE SHOOTING
Q: I press the button on the transmitter but my flash does not light up. Why?
A: Please make sure that:
1. The plastic wrapping on receiver’s battery has been removed.
2. Batteries on both the transmitter and receiver are new.
3. The receiver has been switched to “ON”.
4. The channels of both the transmitter and receiver match each other.
5. When you press the button on the transmitter, the LED on the receiver and
transmitter will light up.
Q: The flash misfires even I did not press the button on the transmitter. What can
I do?
A: Although this trigger has advanced anti-interference design, interference from the
environment is still inevitable. Please move your setup to some other areas and try
again. If misfiring stops, the problem may come from the interference of the
environment.
Interference may occur if you place flashes too close to each other. Try to move the
flashes apart for at least 60cm / 2 feet. Misfiring problem should be resolved.
If misfiring persists, switch to different channels and try again.