Manual

ManualsBrandsHarwin ManualsToolsC90 Braid Adaptors - Tie-Band

IS-33 Issue: 2 Date: 28.04.11 C/Note: 11256 Page 1 of 4

Installation Procedure For Shielding Braid with Tie Bands

Connector range

C90-001-10SL

C90-001-12S

C90-001-14S

Harwin North America Harwin Europe Harwin Asia

T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 386

E: misboston@harwin.com W: www.harwin.com E: mis@harwin.co.uk W: www.harwin.com E: mis@harwin.com.sg W: www.harwin.com.sg

Tie Bands

Tools required for these products include:

BAND-IT Tie-Dex Tool A401 (A490kit)

Torqueleader ADS 25 Torque wrench

3/8” to 1/4” Square drive converter.

TG69 Soft jaw pliers

Summary of content (4 pages)

PAGE 1
Installation Procedure For Shielding Braid with Tie Bands Connector range C90-001-10SL C90-001-12S C90-001-14S Tie Bands Tools required for these products include: BAND-IT Tie-Dex Tool A401 (A490kit) Torqueleader ADS 25 Torque wrench 3/8” to 1/4” Square drive converter. TG69 Soft jaw pliers Harwin North America T: +1 603 893 5376 F: +1 603 893 5396 E: misboston@harwin.com W: www.harwin.com Harwin Europe T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 E: mis@harwin.co.uk W: www.harwin.
PAGE 2
1. 2. Prepare the cable making sure that a sufficient length of shield is available, so that it fits against the front shoulder of the lip groove. (Fig 1) Before insertion of connector contacts, slide the heat-shrinkable connector boot onto the cable, followed by the braid adaptor. Heat Shrink Connector Boot Braid Adaptor Lip groove Cable Shield Braid Fig 1 3. 4. 5. 6. Position the heat shrinkable boot, braid adaptor, and braid out of the way, and insert the connector contacts.
PAGE 3
7. Create a double wrapped clamp (fig 2) by feeding end of band through narrow slot on buckle twice. Pull on clamp by hand to reduce loop diameter for faster installation on small objects. Squeeze gripper release lever and insert band as far as possible. CAUTION: Never use band as a single wrapped clamp! 1 7/8 DIA’ MAX TIE-DEX CLAMP DOUBLE WRAPPED Fig 2 8. Repeatedly squeeze tension handle until handle locks against tool body indicating correct tension.
PAGE 4
10. To loosen or remove clamp after tension handle locks against tool body, squeeze tension handle and push tension release lever forward. Let tension handle return to its original position, then use gripper release lever and pull band out. (Fig 5) Completed clamp (Fig 6) may be covered with shrink wrap or tape for protection. Correctly installed clamp must Have full locking lip on all Tie-Dex and Tie-Dex Microbands.