Owner manual

IS-38 Issue: 2 Date: 07.05.13 C/Note: 12060 Page 3 of 3
EXTRACTION PROCEDURE
To remove a contact from the moulding, select the appropriate Extraction Tool from the handle
and attach as before. Place this tool over the mating end of the contact and push firmly. Care
should be taken to keep the tool perpendicular to the mould face, or mould damage may occur.
Figure 4
Notes:
1) Different Tool Tip for Female and Male
2) Following the extraction of Female contacts from their moulding, re-use of that
moulding is not advised. It is recommended that a new moulding be used to
ensure the integrity of the contact retention in the moulding.
Female Extraction Tool
Male
Moulding
Male
Contact
Male Extraction Tool
Female
Contact
Female
Moulding