User guide

IS-26 Issue: 2 Date: 03.10.07 C/Note: 9874 Page 1 of 3

DATAMATE CABLE HOOD ASSEMBLY INSTRUCTIONS

M80-940, M80-941, M80-942, M80-943 Series

ASSEMBLY INSTRUCTIONS

1. Crimp the contacts (see Instruction Sheet IS-01 for instructions on using Hand Crimp Tool

M22520/2-01 and appropriate Positioner). Insert the contacts into the mould (see

Instruction Sheet IS-25 for instructions on using Datamate Assembly Tool Z80-280). The

completed assembly will resemble this:

2. Place the assembled connector into one half of the cable hood (both halves are identical),

and make sure that all the wires lay within the rear channel of the hood:

Harwin North America Harwin Europe Harwin Asia

T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 3868

E: misboston@harwin.com W: www.harwin.com E: mis@harwin.co.uk W: www.harwin.com E: mis@harwin.com.sg W: www.harwin.com.sg

PAGE 1
DATAMATE CABLE HOOD ASSEMBLY INSTRUCTIONS M80-940, M80-941, M80-942, M80-943 Series ASSEMBLY INSTRUCTIONS 1. Crimp the contacts (see Instruction Sheet IS-01 for instructions on using Hand Crimp Tool M22520/2-01 and appropriate Positioner). Insert the contacts into the mould (see Instruction Sheet IS-25 for instructions on using Datamate Assembly Tool Z80-280). The completed assembly will resemble this: 2.
PAGE 2
3. If added strain relief is required, fit a cable tie around the wires and through the cable tie slots in the rear channel of the hood moulding: 4. Pull the cable tie tight, and then cut off any excess with suitable cutters: IS-26 Issue: 2 Date: 03.10.
PAGE 3
5. Fit the second Cable Hood moulding. Use a No.1 Pozidriv screwdriver to assemble the two retaining screws (one in each side of the hood). Tighten the retaining screws to a torque of 18Ncm – DO NOT OVER-TIGHTEN: 6. Finished Datamate Cable Hood assembly: IS-26 Issue: 2 Date: 03.10.