Manual

ManualsBrandsHarwin ManualsToolsZ20-320

IS-15 Issue: 5 Date: 05.10.2011 C/Note: 11479 Page 1 of 4

HAND CRIMP TOOL Z20-320

Z20-320

-3

22-24

M20-118

This Hand Crimp Tool has been designed for use with the following crimp contacts:

M20-1160042 ................................... 2.54mm Pitch Crimp Contacts, Reeled, Gold

M20-1160046 .................................. 2.54mm Pitch Crimp Contacts, Reeled, Tin

M20-1180042 ................................... 2.54mm Pitch Crimp Contacts, Loose, Gold

M20-1180046 .................................. 2.54mm Pitch Crimp Contacts, Loose, Tin

Harwin North America Harwin Europe Harwin Asia

T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 3868

E: misboston@harwin.com W: www.harwin.com E: mis@harwin.co.uk W: www.harwin.com E: mis@harwin.com.sg W: www.harwin.com.sg

Summary of content (4 pages)

PAGE 1
HAND CRIMP TOOL Z20-320 Z20-320 5 26-30 M20-118 22-24 This Hand Crimp Tool has been designed for use with the following crimp contacts: M20-1160042................................... 2.54mm Pitch Crimp Contacts, Reeled, Gold M20-1160046 .................................. 2.54mm Pitch Crimp Contacts, Reeled, Tin M20-1180042................................... 2.54mm Pitch Crimp Contacts, Loose, Gold M20-1180046 .................................. 2.
PAGE 2
GENERAL INFORMATION The Z20-320 Hand Crimp Tool consists of a ratchet mechanism hand tool and a set of jaws. The jaws comprise of upper and lower crimp dies. The contact is correctly crimped when the tool is free to open at the fully closed position, i.e. when the ratchet releases. CRIMPING PROCEDURE 1. Ensure that the wire to be crimped is within the specified range of sizes for the contact and the crimp tool.
PAGE 3
8. Keeping the cable steady in the crimp, fully close the hand crimp tool until the ratchet releases. Let the crimp tool open. 9. After crimping remove the assembly. The process is then repeated for each crimp required. TOOL MAINTENANCE 1. Keep the tool clean and free from dirt and foreign matter. Ensure that all retaining pins and clips are in place before use, and that signs of wear are not visible. If the pivots are worn, the tool must be replaced, or crimp integrity will be compromised. 2.
PAGE 4
Hex socket grub screw -320 5 Wheel adjustment screw 20-118 3. Re-fit the Hex socket grub screw and tighten. 4. Check the operating force as shown at the top of the page. Repeat the procedure if the force is incorrect. If the adjuster is set to maximum, and operating force is still not achieved, the tool has finished its working life (50,000 crimps minimum), and will need replacing. IS-15 Issue: 5 Date: 05.10.