User Manual

HAND CRIMP TOOL Z22-020

24-30

28-30

24-26

M22-305

M22-308

Z22-020

M22-308

This Hand Crimp Tool has been designed for use with the following crimp contacts:

M22-30400XX.................................. 2mm Pitch Crimp Contacts, Reeled, Gold or Tin

M22-30500XX.................................. 2mm Pitch Crimp Contacts, Loose, Gold or Tin

M22-3060046.................................. 2mm Pitch Crimp Contacts, Reeled, Tin

M22-3080046.................................. 2mm Pitch Crimp Contacts, Loose, Tin

Harwin North America Harwin Europe Harwin Asia

T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 3868

E: misboston@harwin.com W: www.harwin.com E: mis@harwin.co.uk W: www.harwin.com E: mis@harwin.com.sg W: www.harwin.com.sg

IS-05 Issue: 4 Date: 09.06.10 C/Note: 10764 Page 1 of 3

PAGE 1
HAND CRIMP TOOL Z22-020 Z22-020 24-30 M22-305 28-30 M22-308 24-26 M22-308 5 This Hand Crimp Tool has been designed for use with the following crimp contacts: M22-30400XX.................................. 2mm Pitch Crimp Contacts, Reeled, Gold or Tin M22-30500XX.................................. 2mm Pitch Crimp Contacts, Loose, Gold or Tin M22-3060046.................................. 2mm Pitch Crimp Contacts, Reeled, Tin M22-3080046..................................
PAGE 2
GENERAL INFORMATION The Z22-020 Hand Crimp Tool consists of a ratchet mechanism hand tool and a set of jaws. The jaws comprise of upper and lower crimp dies. The contact is correctly crimped when the tool is free to open at the fully closed position, i.e. when the ratchet releases. CRIMPING PROCEDURE 1. Ensure that the wire to be crimped is within the specified range of sizes for the contact and the crimp tool.
PAGE 3
TOOL MAINTENANCE 1. Keep the tool clean and free from dirt and foreign matter. Ensure that all retaining pins and clips are in place before use, and that signs of wear are not visible. If the pivots are worn, the tool must be replaced, or crimp integrity will be compromised. 2. Oil at all pivots and bearings using light cycle oil. 3. At regular intervals, check the crimp tool jaws for wear or damage, and inspect sample crimps for form and function.