User's Manual

Using a Phillips/cross head screwdriver,
loosen the screw in the battery
compartment cover (screw stays attached
to cover). Remove cover. Insert 1 x “9V”/
6LR61 alkaline battery. Replace cover and
tighten screw.
VOL
ON
OFF
ON/OFF/VOLUME
DIAL
CHANNEL SELECTOR
TALK BUTTON
LED ON/OFF
INDICATOR
BELT LOOP
BELT CLIP
The TEAM COMM Headset 2 Player System can be used in two different ways: attach the
headset directly to your ear or attach the headset to the HUD™* (HEADS UP DISPLAY) Unit.
Then, clip or loop the Main Unit directly to your belt.
1. Rotate the TEAM COMM Earpiece
180° clockwise. Snap into the left
side of the HUD (Heads Up Display).
The microphone should be within 2-3
inches of your mouth.
2. Clip or loop the Main Unit directly
to your belt.
TO ATTACH THE TEAM COMM HEADSET 2 PLAYER SYSTEM TO HUD (Heads Up Display):
1. Put on the TEAM COMM Headset so
that the earpiece fits comfortably
over your left ear, and adjust the
microphone so that it is within 2-3
inches from your mouth.
2. Clip or loop the Main Unit directly to
your belt.
TO WEAR TEAM COMM HEADSET 2 PLAYER SYSTEM (WITHOUT HUD):
MAIN UNIT AND EARPIECE
EARPIECE
MIC
VOL
ON
O
FF
TO INSERT BATTERIES
Connect the cable on the Main Unit to the cable on the Earpiece.
CAUTION: TO AVOID BATTERY
LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and
battery manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert item correctly by matching the + and – polarity
markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types
of battery. Always remove from the product before recharging.
Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.