Interactive Star Wars Darth Vader Voice Changer Instruction Manual

ManualsBrandsHasbro ManualsRoboticsStar Wars Darth Vader Voice Changer 85412

VOICE BUTTON

VOICE

SWITCH

PHRASES BUTTON

BREATHING BUTTON

VOICE SWITCH

The voice switch has 3 different settings and a “demo” setting. This toy is

packaged in the “demo” setting for in-store demonstration purposes. You

will need to slide the switch to any of the other 3 settings for full activation of

the features. NOTE: Speech function is disabled in “demo” setting.

The mechanism helps you sound like Darth Vader.

To make your voice sound even more like Vader’s,

try this while using the toy:

• Choose a setting: The 3 settings alter your

voice in different ways. Try each setting to see

which one makes your voice sound closest to

the way Darth Vader sounds.

• Listen to the actual phrases to learn the pace

at which Darth Vader speaks.

• Deepen your voice as you talk.

• Talk slowly and clearly.

• Speak into the microphone and get your mouth as close to the

microphone as possible.

VOICE BUTTON

Wearing the helmet and chestplate, press the Voice Button and speak. Your

voice will change, to sound like Darth Vader’s! See the above instructions on

settings and voice adjustment to fine-tune the sound.

PHRASES BUTTON

Wearing the helmet and chestplate, press the Phrase Buttons to hear Darth

Vader’s actual phrases from the movies!

The phrases are: “You don’t know the power of the dark side.”

“There is no escape.”

“The Force is with you.”

“Your powers are weak.”

“Don’t make me destroy you.”

BREATHING BUTTON

Wearing the helmet and chestplate, press the Breathing Button to hear Darth

Vader’s actual breathing sounds from the movies!

Product and colors may vary.

® denotes Reg. U.S. Pat. & TM Office.

"DEMO"

SETTING #3

SETTING #1

SETTING #2

FCC Statement:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy, and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for help.

TO REPLACE BATTERIES

Loosen screw in battery compartment door with a Phillips/cross head

screwdriver (not included). Remove door. Remove and discard batteries. Insert

3 x 1.5V “AA” or R6 size batteries. Alkaline batteries recommended. Replace

door, and tighten screw.

WEARING HELMET

Place mask on face. Place headgear straight down on head, aligning rib

inside headgear with indentation on back of mask. Slide headgear forward

until you hear a click (tab on front of headgear will lock into slot between

the eyes in the mask). To remove headgear, lift tab on front of headgear.

HEADGEAR

P/N 6748650000

MASK

RIB

TAB

PRESS IN TO LATCH

PULL OUT TO UNLOCK

VOICE SWITCH (Front View)

CHESTPLATE

(See inset above)

IMPORTANT! PLEASE READ INSTRUCTIONS COMPLETELY BEFORE WEARING TOY.

ADJUSTABLE STRAPS

The mask has adjustable straps on the front, sides and back. To adjust,

lift straps off posts, slide straps to desired position, and press straps

onto posts.

SIDE

FRONT

BACK

AGES 5

through adult

85412

CAUTION:

1. Always follow the instructions carefully. Use only batteries

specified and be sure to insert them correctly by matching the +

and – polarity markings.

2. Do not mix old batteries and new batteries, or standard (carbon-

zinc) with alkaline batteries.

3. Remove exhausted or dead batteries from the product.

4. Remove batteries if product is not to be played with for a long

time.

5. Do not short-circuit the supply terminals.

6. Should this product cause, or be affected by, local electrical

interference, move it away from other electrical equipment.

Reset (switching off and back on again or removing and re-

inserting batteries) if necessary.

7. RECHARGEABLE BATTERIES: Do not mix these with any

other types of battery. Always remove from the product before

recharging. Recharge batteries under adult supervision. DO NOT

RECHARGE OTHER TYPES OF BATTERIES.

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference.

Batteries should be replaced by an adult.

CAUTION:

TO AVOID BATTERY LEAKAGE

1. Be sure to insert the batteries correctly and

always follow the toy and battery manufacturers’

instructions;

2. Do not mix old and new batteries or alkaline,

standard (carbon-zinc) or rechargeable (nickel-

cadmium) batteries;

3. Always remove weak or dead batteries from the

product.

BATTERIES INCLUDED

1.5V AA/R6 size

Replace with 3 x 1.5V “AA” or R6 size batteries.

Alkaline batteries recommended. Phillips/cross

head screwdriver (not included) needed to

replace batteries.

P I L A S I N C L U I D A S

AA/R6 (1,5 V)

A reemplazar por 3 pilas AA o R6 de 1,5 V con

un destornillador en cruz (no incluido). Se

recomiendan pilas alcalinas.