Installation & Assembly

Assembly Instructions

Contains One Bed and Hardware

STEP 4

STEP 6

STEP 5

STEP 7

ASSEMBLY INSTRUCTIONS (CONTINUED)

A A

Attach the complete Side Rails to the Headboard (Part A) and

Footboard (Part B) by sliding the side rail brackets onto the bolts

on the Headboard Legs (Part D) and Footboard (Part B). Do not

tighten yet.

Attach the Side Rail Legs (Part F) to the Side Rails (Part C1 and C2)

using 30mm Bolts (Part K) and Flat Washers (Part R). Tighten

using Large Hex Key (Part N).

Attach the Center Leg (Part I) to the Slat (Part H) using 35mm Bolt

(Part L). Tighten the bolt using Large Hex Key (Part N). Repeat this

process for all 4 Support Legs.

Place the four slats into the bed as shown. Tighten the bolts on

the headboard legs and footboard using Small Hex Key (Part O).

Secure the 4 slats using eight Screws (Part P) and a Phillips

Screwdriver. Your bed is now set up and ready for use.

PAGE 1
ASSEMBLY INSTRUCTIONS (CONTINUED) STEP 4 STEP 5 N Assembly Instructions K Contains One Bed and Hardware R A F C C2 F C1 B Attach the Side Rail Legs (Part F) to the Side Rails (Part C1 and C2) using 30mm Bolts (Part K) and Flat Washers (Part R). Tighten using Large Hex Key (Part N). Attach the complete Side Rails to the Headboard (Part A) and Footboard (Part B) by sliding the side rail brackets onto the bolts on the Headboard Legs (Part D) and Footboard (Part B). Do not tighten yet.
PAGE 2
IMPORTANT NOTE: ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: Carefully remove all the parts from the box. Arrange on a flat surface and verify you have all of the following parts and hardware. Phillips Screwdriver STEP 1 PARTS LIST B E A. Headboard Top (1 pc) B. Footboard (1 pc) C. Side Rail (4 pcs) Unzip the black fabric on the back of the headboard and remove the parts. Zip the black fabric closed after parts are removed.