User's Manual

105
ON.OFF
(PROFILES/ESC)
1
�
�
2


AF
Load
3
ON.OFF
(PROFILES/ESC)
1
�
�
2


AF
Load
3
ON.OFF
(PROFILES/ESC)
4
5


To use a profile from the main screen, press the PROFILES button
to reach the profiles screen again. Scroll down the list to the profile
you want and then press the Load (AF) button. All the saved set-
tings will then be automatically implemented.
 If you decided to change the settings but nevertheless keep
the Profile name on the list, the new set of parameters will be
retained under that name. That is to say, the settings will not
be the same as listed here, despite the name. It might be safer
practice to always change the profile name to avoid later
confusion.
Using profiles
1) From the main screen, click PROFILES (ON.OFF button) on
the grip and the profile screen will appear.
2) Use either the front or rear control wheel to scroll through the
list and highlight the desired profile.
3) Press Load (AF button). The camera is now set according to
all the parameters stored according to the name.
Changing a profile name
You can change a profile name (except ‘Standard’) at any time.
Proceed as follows:
1) From the main screen, click PROFILES (ON.OFF button) on
the grip and the profile screen will appear.
2) Use either the front or rear control wheel to scroll through the
list and highlight the desired profile.
3) Press Load (AF button).
4) Click PROFILES (ON.OFF button) again.
5) Press Save (DRIVE button)
6) The Profile name screen is then displayed where you can
rename the profile to what suits you (see section Imprint / Text
4.2.2 further on in this manual for procedure details).