User's Manual

11
2
1
19
20
21
22
13
14
17
15
16
18
13. While holding the viewfinder at a slight angle, locate the
front section into place on the front edge of the viewfinder
screen recess in the camera body ensuring the central locat-
ing lug and databus interface are positioned correctly.
Swing the viewfinder downwards and press firmly until it
clicks into place. Ensure that both sides of the viewfinder are
seated correctly.
14. Point the camera at a smooth toned area. Turn the eyesight
adjustment dial until you achieve optimum sharpness of the
markings on the viewfinder screen.
..........................................................................
Sensor unit with CF card
15. Open the card-holder cover on the sensor unit by insert-
ing your fingernail into the slot at the front of the door and
swinging it open.
16. Hold the compact-flash card so that the connector holes face
into the slot in the sensor unit, with the brand label facing in
the same direction as the sensor unit preview screen.
17. Gently press the card into the slot. If you encounter resist-
ance, it might be because you are holding the card back-
wards or upside down. Experiment until you find the orienta-
tion that allows the card to slide in easily.
18. When the card is able to drop very easily nearly all the way
into the sensor unit, then you are doing it right. Once you
have achieved this, press the card firmly into place until it
sinks another couple of millimeters into the sensor unit and
is held fast. Swing the side panel door shut again.
..........................................................................
Film loading
19. Fold out the film holder key.
20. Turn the key counter-clockwise 90° and withdraw the film
holder completely. (Remove the protective slip from the inter-
nal battery compartment if necessary)
21. Place an empty take-up spool in the upper spool holder
by pushing one end of the spool against the sprung spool
retaining arm to engage the stud in the spool end. Position
the other end of the spool over the fixed stud in the holder.
Rotate the spool a little if necessary until clicks into position.
22. Completely remove the retaining paper band from a new
roll of film and place it in the lower spool holder in the same
manner as the empty spool. Ensure you do not place the new
film spool the wrong way around! See diagram for correct
orientation.