User's Manual

12
3231
3029
28
27
2625
2423
2
1
23. Pull 8–10 cm (3–4 in) of paper backing from the film roll and
insert the tongue of the backing paper into the slot in the
take-up spool.
24. Turn the take-up spool one complete turn to ensure the
tongue is firmly held in place by the overlying paper backing.
Check diagram for correct film travel direction.
25. Re-insert the film holder into the main body of the film mag-
azine ensuring the correct orientation. Press firmly inwards
towards the magazine and pay particular attention to see
that both sides are level with the magazine body before
turning the film holder key clockwise 90° to lock the film
holder in place and fold the key back into its stored position.
You might find that increased pressure on the left hand side
of the film holder will more easily ensure a positive and cor-
rect positioning in the magazine.
26. The film will now be wound automatically by the camera
to the first frame position if the camera is in active mode.
Otherwise, activate the camera by holding down the ON/
OFF button for half a second.
27. Fold out the magazine slide key and turn it counter clockwise
360° until it stops. Fold the key back into its storage position.
28. Ensure the magazine setting lock is in the forward (unlocked)
position.
29. If the film has a Barcode, go direct to step 32. If the film has
no Barcode, press the function selector button
on the film
magazine repeatedly until a figure and ISO appears. Press
either the change up
or change down buttons
until
you see the correct ISO rating for the film in use.
30. Press the function selector button
repeatedly again until
you see the film length designation (120 or 220).
31. Press either the change up
or change down buttons
until you see the correct number of frames correct for the
film (8 Fr, 16 Fr or 32 Fr).
32. Insert a tab from a film carton in the holder on the back of
the magazine to remind you which film you have loaded.
..........................................................................