User's Manual

138
4. Finally check if the IR filter has been properly cleaned either by visual inspection or
by mounting the sensor unit to the camera and making a shot. If further cleaning is
needed, repeat cleaning procedure.
Cleaning with an E-Wipe
E-wipes are individually packed wet tissues.
1. Tear at the notch to break seal.
2. Remove e-wipe from its packaging and continue without delay.
3. Fold the tissue to match the width of the IR filter.
4. Apply firm pressure using two or three fingers at the edge of the wipe to ensure an
even, firm contact with filter surface. Wipe the surface in one unbroken motion.
 Note! Do not use same side of the e-wipe twice as you will be likely to reapply any
particles removed in the first pass.
5. Finally check if the IR filter has been properly cleaned either by visual inspection or
by mounting the sensor unit to the camera and making a shot. If further cleaning is
needed, repeat cleaning procedure.
Attaching the sensor unit
Position the sensor unit retention groove onto the sensor unit support on the camera body
ensuring that they are correctly positioned. Swing the sensor unit towards the camera
body and firmly press into place with a click. If there is resistance, the magazine retain-
ing catch on the camera has probably been inadvertently released. In that case, push the
release button again to reset the catch.
Cleaning the housings
If the camera becomes dirty, clean it with a so, clean cloth lightly moistened with water
only. Do not use any other solvents and do not allow water to seep in the openings..