User's Manual

There is also a one-button short-

cut for toggling the overexpo-

sure marker on and oﬀ.

To use it, press and hold 

until the indicator is working

as you would like (enabled or

disabled).

 Overexposure

indicator shortcut !

Battery-saver mode

In this mode, the sensor unit is fully responsive, so you can take pictures but the screen

is not lit up, thereby saving battery power.

You can enter the menu system while shooting in this mode (which activates the screen

until you exit the menu system again) but the approval, zoom and navigator buttons

have no eﬀect.

 You can also save battery power by turning down the brightness and/or contrast of the

display using the entries of the MAIN MENU > SETTINGS > USER INTERFACE > DISPLAY

menu. See ‘Making Display Settings’ for details.

 Other ways to save battery power include setting a display time-out and/or a power-

down time-out (each of these is disabled by default). Use MAIN MENU > SETTINGS >

USER INTERFACE > Power Down to set a power-down time out. Use MAIN MENU >

SETTINGS > USER INTERFACE > DISPLAY > Timeout to set a display time-out. See also

‘Entries of the USER INTERFACE Menu’ and ‘Making Display Settings’ for details about

these settings.

Full-Screen Mode 1

In full-screen mode, you can browse your images at standard preview resolution without

any distracting data surrounding them.

Because the current approval setting is not shown in full-screen mode, the approval

button has no eﬀect. is will prevent you from accidentally assigning the wrong status

without knowing it.

Overexposure indicator 2

ough the histogram shows you when some of your pixels are overexposed, it does not

tell you which ones. In a shot with many bright areas, it can be hard to know whether

the key parts of your image are just bright or completely overexposed. To help you ﬁnd

them, the sensor unit can provide an overexposure indicator, which shows precisely

which areas of your shot are overexposed (i.e., pixels that are at maximum brightness,

thereby eliminating details).

When enabled, the overexposure indicator ﬂashes the overexposed pixels from black

to white.

To enable or disable the overexposure indicator, use the MAIN MENU > SETTINGS >

USER INTERFACE > Mark Overexp. entry.

Please see Entries of the USER INTERFACE Menu for a detailed procedure.