User's Manual

98
1
A
B
3
+/-


4
�
�
2
5
Alternatively, you can also pre-set the initial zone reading in order
to save time and effort where there is no freely available ‘zone 5’
subject for light measuring. For example, you might be on a sandy
beach where you know that sand is normally classified as zone 6.
You can pre-programme the zone placement by holding down
the AE-L button while choosing the new zone value and turning
the front control wheel until zone 6 appears. Pointing the camera
at other parts of the scene will now display their zone values (in
relation to the initial setting of sand at zone 6) to see whether they
still lie within the sensitivity range and how they might appear
in the result.
Exposure compensation 1, 2, 3, 4, 5
e exposure compensation facility, for both manual and automatic
modes can be set from -5 to +5 EV, in 1/3 EV increments. is
facility will adjust the exposures by the set amount until changed
and the setting is visible above the scale in the viewfinder and as
a ± symbol on the grip LCD.
To make a fixed exposure compensation setting, proceed as follows
with the camera in active mode:
1) Press the +/- button on the viewfinder.
2) Turn either the front or rear control wheels to increase or decrease
the amount of compensation in 1/3 EV steps.
3) The amount is displayed in the viewfinder as both an EV figure
complete with a ‘minus’ or ‘plus’ prefix (A in illustration) , and
as a marker above a ‘minus’ to ‘plus’ scale with a central index
signifying zero compensation (B in illustration).
4) Press Save (DRIVE button) to retain the setting.
5) A ‘±’ symbol is then displayed between the aperture and shut-
ter speed setting as confirmation of the setting.