User's Manual

Using the headset
Answering calls
▪ When the phone rings, headset rings and the indicator flashes red.
▪ Press the ‘Talk and Power button’.
▪ To reject a call, press ‘Volume-up button’ or ‘Volume-down button’.
But, for this function, your mobile phone need to support the reject function.
▪ To End the call, press the ‘Talk and Power button’.
Making calls
[Voice dialing]
▪ To make a call using your headset, your mobile phone need to support voice dialing and it is
activated.
▪ Press ‘Talk and Power button’ and you can hear a short beep. Voice dial as you normally would.
▪ To End the call, press the ‘Talk and Power button’.
[To make a call using your mobile phone]
precondition
: make sure that your headset is connected to your mobile phone by checking your
headset indicator flashes green every 10 seconds (With some phone models, it flashes green every 5
seconds)
▪ Using the phone’s keypad, dial.
▪ Send the call in the phone. (Phone initiate the call.)
▪ The call will automatically transfer to the headset.
But for some phones, you should press ‘Talk and Power button’ to make transfer the call to the headset.
Therefore, refer to the phone’s user guide.
▪ To End the call, press the ‘Talk and Power button’.
[To make a call using phone’s re-dial function for the last call]
▪ You can make a call using your headset but it is limited to the last call regardless of it’s dialed call
or received call.
▪ Press ‘Talk and Power button’ then your mobile phone will search the last call.
▪ Press ‘Talk and Power button’ again.
▪ After you hear the short beep, you can hear the calling signal from speaker.
▪ To End the call, press the ‘Talk and Power button’.
Adjusting the volume
You can adjust the headset speaker volume during a call using ‘Volume-up button’ or ‘Volume-down
button’. If you are not on the line, you cannot adjust the volume. The headset has the middle
volume level as its default.
▪ To increase the volume, press ‘Volume-up button’.
: If, by pressing ‘Volume-up button’, the volume reaches to the highest level,
whenever you press ‘Volume-up button’ again, High beep will be generated.
▪ To decrease the volume, press ‘Volume-down button’.
: If, by pressing ‘Volume-down button’, the volume reaches to the lowest level,
whenever you press ‘Volume-down button’ again, Low beep will be generated.