User Guide

https://www.thermo-hyg ro.com

1 / 3

STC-200 Thermostat

Quick Start Guide

(Version 21.08.02GEN)

STC-200+ thermostat with just one relay to control the

power supply status of the wired heater or cooler or

output alarm.

1. Wiring Diagram

2. Set the Aimed Temp Range

The aimed temperature range was defined from “SP” to

“SP + F0”; hence you need to set both the “SP” and the

“F0” value.

PAGE 1
STC-200 Thermostat Quick Start Guide (Version 21.08.02GEN) STC-200+ thermostat with just one relay to control the power supply status of the wired heater or cooler or output alarm. 1. Wiring Diagram https://www.thermo- hyg ro.com 2. Set the Aimed Temp Range The aimed temperature range was defined from “SP” to “SP + F0”; hence you need to set both the “SP” and the “F0” value.
PAGE 2
3. Function Menu Code Function F0 F1 F2 F3 F4 F5 Temperature Hysteresis / Difference Protection Delay Time for the Compressor Lower Limit for SP Setting Upper Limit for SP Setting Refrigeration or Heating or Alarm Mode Calibration = Real. - Measured. 3.1. Set the “SP” value 1) 2) Press the key, shows the exists SP value; Press the or keys to change SP, ro.com which F2 and https://www.thermohyg F3 limited; 3) It will back to normal status from the setting interface in the 30s if without operation.
PAGE 3
back to the menu list. 4) Hold the key for 3s to saves data and back to normal monitor status. 5) Repeat steps 2,3,4 to change others. 6) Hold the key for 3s to quit from setting or leave it alone; it will back to normal status in the 30s if without operation. This is not a step-by-step user manual; It just shows the key points. https://www.thermohyg ro.