User Guide

ManualsBrandsHatco ManualsOtherFDWM-0602

FLAV-R-FRESH

Holding & Display Cabinets

FDW Series

Installation &

Operating Manual

I&W #07.05.013.00

This manual contains important safety information

concerning the maintenance, use and operation of

this product. Failure to follow the instructions

contained in this manual may result in serious injury.

If you are unable to understand the contents of this

manual, please bring it to the attention of your

supervisor. Do not operate this equipment unless

you have read and understood the contents of

this manual.

Este manual contiene importante información sobre

seguridad concerniente al mantenimiento, uso

y operación de este producto. Cualquier falla en

el seguimiento de las instrucciones contenidas en

este manual puede resultar en un serio daño. Si usted

no puede entender el contenido de este manual por

favor pregunte a su supervisor. No opere este equipo

al menos que haya leído y comprendido el contenido

de este manual.

nbfehvijfhvjeivfei

fgjehjehjevhjevhejiivhui

ghjilgvijfdegvfeghejghej;

vjfevjneko;vjek;ejnoo

nbfehvijfhvjeivfei

fgjehjehjevhjevhejiivhui

ghjilgvijfdegvfeghejghej;

vjfevjneko;vjek;ejnoo

nbfehvijfhvjeivfei

fgjehjehjevhjevhejiivhui

ghjilgvijfdegvfeghejghej;

vjfevjneko;vjek;ejnoo

nbfehvijfhvjeivfei

fgjehjehjevhjevhejiivhui

ghjilgvijfdegvfeghejghej;

vjfevjneko;vjek;ejnoo

Summary of content (16 pages)

PAGE 1
FLAV-R-FRESH ® Holding & Display Cabinets FDW Series Installation & Operating Manual I&W #07.05.013.00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor.
PAGE 2
CONTENTS Display Racks .........................................................4 Legs .........................................................................4 Glass Panels ............................................................4 Reversible Access Door ..........................................5 Striker Plate Replacement.......................................5 Location ..................................................................5 Operation........................................................
PAGE 3
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT! Read the following important safety instructions to avoid personal injury or death, and to avoid damage to the equipment or property. WARNINGS WARNINGS To prevent electric shock or injury, turn the power switch off, unplug the unit from the power source and allow to cool completely before performing any maintenance or cleaning. Genuine Hatco Replacement Parts are specified to operate safely in the environments in which they are used.
PAGE 4
MODEL DESCRIPTIONS ALL MODELS All display cabinets feature stainless steel construction with incandescent lights, tempered glass sides and door. The standard access door can be hinged left or right, optional French doors are available. The pretzel tree is stainless steel and the other display racks are chrome-plated.
PAGE 5
SPECIFICATIONS PLUG CONFIGURATIONS Units are supplied from the factory with an electrical cord and plug installed. Plugs are supplied according to the applications as shown in Figure 3. WARNING Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration. If the plug and receptacle do not match, contact a qualified electrician to determine the proper voltage and size and install the proper electrical outlet.
PAGE 6
SPECIFICATIONS DIMENSIONS - FDW MODELS Width (A) Depth (B) Height (C) 18" (46 cm) 19-1/2" (50 cm) 27-1/2" (70 cm) FDW-2 18" (46 cm) 20-7/8" (53 cm) 27-1/2" (70 cm) FDW-1X 18" (46 cm) 19-1/2" (50 cm) 27-1/2" (70 cm) FDW-2X 18" (46 cm) 20-7/8" (53 cm) 27-1/2" (70 cm) Model FDW-1 B A CABINET TEMPERATURE F POWER MED 4 3 WATER FILL 2 5 LOW HIGH HUMIDITY 1 6 TEMPERATURE C Figure 4.
PAGE 7
INSTALLATION CAUTION The unit must be transported in an upright position. If laid on its side, all glass surfaces must be secured with tape, and water must be drained from the unit. REVERSIBLE ACCESS DOOR The Flav-R-Fresh access door may be hinged on either the left or right side for your convenience. See Figure 6. To reverse the door hinge, follow these instructions: 1. Remove the top hinge pin screw holding door to hinge. Remove nylon washer. 2.
PAGE 8
OPERATION 1. Plug the cabinet into a properly grounded electrical outlet of the correct voltage, size and plug configuration. See ELECTRICAL SPECIFICATIONS for details. On/Off Switch Humidity Selector Temperature Indicator 2. Place the power switch in the “on” position. The humidity cycle and low water indicators will light up at this time. See Figure 7. CAUTION Water Quality Requirements – Incoming water in excess of 3.0 grains of hardness per gallon (GPG) (.
PAGE 9
OPERATION FOOD HOLDING GUIDE Type of Food Biscuits Chicken Pieces (Fried) Croissants Fruit Pies Onion Rings Pizza - Thick Crust - Thin Crust Pretzels Wrapped Sandwiches Maximum Holding Time 4 Hours 4 Hours 4 Hours 3-1/2 Hours 1/2 to 1 Hour 1 Hour 1 Hour 3 Hours 2 Hours Humidity Setting 4 7 1 4 1 4 5 4 4 Setting 2.5 5 3 3 5 6 5.5 3 5.
PAGE 10
MAINTENANCE CLEANING WARNING To prevent electric shock or injury, turn the power switch off, unplug the unit from the power source and allow to cool completely before performing any maintenance or cleaning. WARNING To prevent any injury discontinue use if power cord is frayed or worn. Hatco Flav-R-Fresh cabinets are made of stainless steel and aluminum. To preserve the bright finish, it is recommended that the exterior and interior surfaces be wiped daily with a damp cloth.
PAGE 11
MAINTENANCE DISPLAY LIGHT BULB REPLACEMENT Once the unit has finished draining, the drain assembly can be removed by pressing the release tab and gently pulling the fitting out. The display light is an incandescent bulb which illuminates the warming area. This bulb has a special coating to guard against injury and food contamination in the event of breakage. The Hatco Flav-R-Fresh Holding and Display Cabinets are designed for maximum durability and performance, with minimum maintenance.
PAGE 12
ACCESSORIES 4" (10 cm) ADJUSTABLE LEGS To install the 4" (10 cm) appliance legs, place the unit on its side. Be sure to secure all glass with tape. Remove the four (4) 1" (2.5 cm) metal screw type feet. Screw the 4" (10 cm) legs into the holes provided. After all the legs are tightened, return the unit to its upright position. If the unit is not level or rocks, turn the adjustable tip of the appropriate leg to correct the condition. See Figure 9.
PAGE 13
HATCO LIMITED WARRANTY THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR PATENT OR OTHER INTELLECTUAL PROPERTY RIGHT INFRINGEMENT.
PAGE 14
NOTES Form No.
PAGE 15
NOTES 13 Form No.
PAGE 16
HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA KENTUCKY NEW YORK (continued) TEXAS Jones McLeod Appl. Svc. Birmingham 205-251-0159 GCS Service Louisville 502-3671788 Appliance Installation Buffalo 716-884-7425 Stove Parts Supply Fort Worth ARIZONA LOUISIANA Auth. Comm. Food Equip. Phoenix 602-234-2443 Chandlers Parts & Service Baton Rouge 225-272-6620 Northern Parts Dist. Plattsburgh 518-563-3200 Armstrong Repair Service Houston 713-666-7100 Byassee Equipment Co.