User Guide

Form No. GRSDM-0903
1
IMPORTANT SAFETY INSTRUCTIONS
WARNINGS
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool before performing any cleaning
or maintenance.
Plug unit into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do not
match, contact a qualified electrician to determine
the proper voltage and size and install the proper
electrical outlet.
Unit is not waterproof. To avoid electrical shock
or personal injury DO NOT submerge
in water. Do not operate if it has been submerged
in water.
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the unit.
For safe and proper operation, the unit must
be located a reasonable distance from combustible
walls and materials. If safe distances are
not maintained, discoloration or combustion
could occur.
Do not lay unit on the side with the control panel
or damage to unit could occur.
To prevent any injury or damage to the unit
do not pull unit by power cord.
To prevent any injury, discontinue use if power
cord is frayed or worn.
For safe and proper operation do not place
food product directly onto hardcoat surface.
Food product must be wrapped, boxed
or on a food pan.
Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food holding
areas must be used. Breakage of light bulbs not
specially coated could result in personal injury
and/or food contamination.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax [phone]
or International fax [phone].
This product has no “user” serviceable parts.
To avoid damage to the unit or injury
to personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Replacement Parts
when service is required.
WARNINGS
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the characteristics
that will allow them to operate safely in
Hatco equipment. It is essential to use Hatco
Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment
to hazardous electrical voltage, resulting
in electrical shock or burn.
CAUTIONS
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
To avoid any injury or damage locate the unit
at the proper counter height, in an area that
is convenient for use. The location should
be level to prevent the unit or its contents from
accidentally falling, and strong enough to support
the weight of the unit and food displayed.
The National Sanitation Foundation (NSF)
requires units over 36" (914 mm) in length
or weighing more than 80 lbs. (36 kg) to be either
sealed or raised on the installation surface.
If this unit cannot be sealed at the point of use,
4" (102 mm) legs are included to allow for proper
cleaning access below unit.
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where
the ambient air temperature is constant
and is a minimum of 70°F (21°C).
CAUTIONS
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish marring
its appearance and making it susceptible
to dirt accumulation.
Only soft cleaning cloths with mild soap
and water should be used to clean breath
protector(s). Breath protector(s) are made
of shatterproof polycarbonate and will scratch
or crack if proper care is not taken.
IMPORTANT! Read the following important safety instructions to avoid personal injury or death,
and to avoid damage to the equipment or property.