Instructions / Assembly

4. Insert PLAYER RODS through holes on other SIDE PANEL #7 and attach to each END PANEL #8 with
CORNER #17 and 1/2” SCREW #4 as you did in step 1.
5. Attach two PLAYFIELD SUPPORT BRACE #16 underneath PLAYFIELD by fastening to SIDE PANELS with
1-1/2” SCREW #3.
6. Attach one LEG #10 to each corner of the table using BOLT #1, FLAT WASHER #5 and NUT #20, which is
inserted into back of LEG hole.
7. Carefully turn table over.
8. Attach HAND GRIP #12 to each PLAYER ROD of the same team color, on the same side of the table, as
shown below. Attach ROD END CAPS #15 to the opposite end of PLAYER RODS.
CAUTION: Player Rod metal ends may be sharp. Be careful when attaching hand grips
and rod end caps to avoid injury. This should be done by an adult.
9. Attach one TWO-PIECE GOAL #5 to each end of the table with 1/2” SCREW #4 using pre-drilled holes.
#2
#2
#10
#3
#16
#3
#1
#4
#4
#1
#20