Use and Care Manual

ASSEMBLY INSTRUCTIONS (CONT.)
10
Figure 7
14. Assemble LEFT and RIGHT MIDDLE LEGS, P2L and P2R, together with SPREADER, P4, using (4) SCREWS, H1,
as shown in Figure 7. Note: Hand place screws in all four pre-drilled holes to align panel before tightening. Attach “L”
SUPPORT PANEL, P22, in same manner using (6) SCREWS, H10, as shown.
15. Attach Middle Leg Assembly between assembled sides, P7L and P7R, using (2) BOLTS, H2, and (2) WASHERS, H3,
on each leg, as shown in Figure 7. Note: Velcro will be used as wire harness in future step.
16. Attach LEFT and RIGHT BACK LEGS, P3L and P3R, using (2) BOLTS, H2, and (2) WASHERS, H3, on each leg, as
shown in Figure 7. Note: Hand tighten for now, and then do final tightening with ALLEN WRENCH, T1, once P4 Spreader
is attached in next step.
17. Attach SPREADER, P4, between Legs using (4) SCREWS, H1, as shown in Figure 7.
Note: Hand place screws in all four pre-drilled holes to align panel before tightening.
CAUTION:
P4 SPREADER MUST BE CENTERED
CORRECTLY ONTO PRE-DRILLED HOLES
IN LEGS BEFORE ATTACHING WITH H1
SCREWS.
P4
P3L
P3R
H2
H3
H1
Note: Correct location
Velcro
P22
H2 H3
P4
P2L
P2R
H1
H10
P22
of Support Panel to Legs