Instruction Manual

5
Section VII. OPERATING INSTRUCTIONS
Warning!
1. Before filling the air cylinder; make sure the safety is in the ON position, no pellets
are loaded in the air rifle and/or barrel and magazine is not mounted in the gun. If
the air tube is completely empty; fill in air tube after cocking the gun and keeping
the cocking handle/bolt open at the rear.
2. Take all safety measures before filling the air cylinder. It is compulsory for the user
and bystanders to wear eye & ear protection when filling the air cylinder.
3. While filling in the air cylinder; the pressure in the air cylinder must be monitored
from the air gauge of the hand pump or scuba charging kit. Do not look at the air
gauge on the air cylinder during filling process. Instead, reference the gauge on
your fill device.
Charging the Rifle:
1. Pull the cocking handle backwards until it stops and locks at the back. Keep the cocking handle open at the rear.
(Fig,8) THIS OPERATION COCKS THE TRIGGER MECHANISM/HAMMER ASSEMBLY. IF THE SAFETY IS
SET TO OFF POSITION AND THE TRIGGER IS PULLED, THE RIFLE WILL DISCHARGE.
2. Fit the filler nozzle to the air-line of the charging equipment, which must incorporate a pressure gauge. (Fig 9)
Ensure both filler nozzle and rifle filler hole are clear from dirt and gently push the nozzle into the filler hole.
3. Fill the rifle to the cylinder pressure quoted previously in this manual. Do not exceed the maximum fill pressure as
this will reduce the velocity of the rifle and may damage rifle components and may cause danger to you and others
around you. When using the diver’s bottle, refill the rifle slowly to prevent the heat created by the filling process
from damaging the rifles components.
4. Undo the bleeder valve on the hose before disconnecting the fill nozzle from the rifle.
Loading the rifle & shooting
1. The magazine incorporates a raised boss on its rear face and can only be fitted one way to the rifle. It rotates
clockwise when viewed from the rear of the rifle.
2. Load pellets through the rear of the magazine. (Fig. 10). Push the pellet noses
through the retaining O-ring until their skirts lie flush or below the bottom of
the magazine face.
3. To fit the magazine into the air rifle; pull the cocking handle backwards until
it stops. (Fig. 8)
THIS OPERATION COCKS THE TRIGGER MECHANISM/HAMMER AS-
SEMBLY. IF THE SAFETY IS SET TO OFF POSITION AND THE TRIGGER
IS PULLED, THE RIFLE WILL DISCHARGE.
4. Push forward the magazine release bolt. (Fig. 8) Insert the magazine into its slot from the right. (Fig.11)
5. Unlock magazine release bolt by sliding backwards. (Fig. 11). If necessary rotate the magazine counter-clockwise
until its movement is arrested by the magazine stop.
DO NOT CLOSE THE COCKING HANDLE / MAGAZINE RELEASE BOLT UNTIL YOU ARE READY TO FIRE.
Fig. 10
Fig. 8 Fig. 9
1
2