Instruction Manual

5
Section VI. OPERATING INSTRUCTIONS
Warning!
1. Take all safety measures before filling the air cylinder. It is compulsory for the user and bystanders to
wear eye & ear protection when filling the air cylinder.
2. Before filling the air cylinder; make sure the safety is in the ON position, no pellets are loaded in the air
rifle and/or barrel and magazine is not mounted in the gun. If the air tube is completely empty; fill air
tube after cocking the gun and keeping the cocking handle/bolt open at the rear.
3. While filling the air cylinder; the pressure in the air cylinder must be monitored from the air gauge of the
hand pump or scuba charging kit. Do not look at the air gauge on the air cylinder during filling process.
Instead, reference the gauge on your fill device.
Charging the Rifle:
1. Pull the cocking handle backwards until it stops and locks at the
back. Keep the cocking handle open at the rear. (Fig. 5) THIS
OPERATION COCKS THE TRIGGER MECHANISM/HAMMER
ASSEMBLY. IF THE SAFETY IS SET TO OFF POSITION AND THE
TRIGGER IS PULLED, THE RIFLE WILL DISCHARGE.
2. Fit the filler nozzle to the air-line of the charging equipment,
which must incorporate a pressure gauge. (Fig. 6) Ensure both
filler nozzle and rifle filler hole are clear from dirt and gently push
the nozzle into the filler hole.
3. Fill the rifle to the cylinder pressure quoted previously in this
manual. Do not exceed the maximum fill pressure as this will
reduce the velocity of the rifle and may damage rifle components
and may cause danger to you and others around you. When using the diver’s bottle, refill the rifle slowly to
prevent heat created by the filling process from damaging the rifles components.
4. Undo the bleeder valve on the hose before disconnecting the fill nozzle from the rifle.
Loading the rifle & shooting
1. The magazine incorporates a raised boss on its rear face and can only be
fitted one way to the rifle. It rotates clockwise when viewed from the rear of
the rifle.
2. Load pellets through the rear of the magazine. (Fig. 7). Push the pellet
noses through the retaining O-ring until their skirts lie flush or below the
bottom of the magazine face.
3. To fit the magazine into the air rifle; pull the cocking handle backwards until
it stops. (Fig. 5)
THIS OPERATION COCKS THE TRIGGER MECHANISM/HAMMER ASSEMBLY. IF THE SAFETY IS SET TO OFF
POSITION AND THE TRIGGER IS PULLED, THE RIFLE WILL DISCHARGE.
4. Push forward the magazine release bolt. Insert the magazine into its slot from the right. (Fig. 5)
5. Unlock magazine release bolt by sliding backwards. (Fig. 8). If necessary rotate the magazine counter-
clockwise until its movement is arrested by the magazine stop.
DO NOT CLOSE THE COCKING HANDLE / MAGAZINE RELEASE BOLT UNTIL YOU ARE READY TO FIRE.
Fig. 6
Fig. 7
Fig. 5 Fig. 8
Hose
Filler Nozzle
Air Gauge
1
5
2
4
3