Manual

Physical Connections

IND100133-32

Note: Other Multifunction Cables may include other connections based on a customized solution.

MULTIFUNCTION CONNECTOR:

Mount the 160 PIN cable connector (male) to the 160 PIN connector (female) on the back of the unit as indicated

above. Make sure you fasten it rmly with the provided housing screws to the hex spacers provided on the unit. By

using this cable you can access more signal types than already present by the factory mounted connectors. By factory

standards two cables are available. One for non-touch screen based unit and one for units with factory mounted touch

screen. From this cable you can now have access to the following signal types described below.

3 x COMPOSITE IN/VIDEO IN (if present):

Connect your BNC cable connector (male) to any of the 3 available BNC Connectors (female) on the unit. This will

allow 3 different video signals from i.e. cameras & dvd players to be visible on screen either as full screen video or

Picture-In-Picture/Picture-By-Picture. To activate any of these functionalities, the unit must be configured via the OSD

menus (see own chapter). PAL / NTSC / SECAM VIDEO signal formats supported.

COM RS-232 (if present):

This 9P COM connector provides additional functionality for the unit. The Serial Remote Control features a RS232

interface for controlling internal MMD parameters like brightness. You can access most of the parameters available in

the OSD menu and with special commands control the unit externally.

An in-depth manual is available at http://www.hatteland-display.com/pdink/inb100018-3.php. This COM can also be

used to upgrade the rmware for the graphic controller inside the unit which is available on request and through

service channels (for qualied personnell only).

COM TOUCH (if present):

This 9P COM connector provides touch screen communication for units that have been equipped with a factory

mounted touch screen. It should be connected to a computer with touch screen drivers installed. See the touch screen

chapter in this manual for more information.