Manual

User Controls

IND100064-21

OSD Menu Functions

The following section covers all possible settings that the user can (in a certain mode) encounter or needs

to adjust. The structure of these commands are identied as paths. Please review the “OSD Menu

Overview Map” earlier in this manual to see the different paths if you have not already made yourselves

familiar with the OSD Menu structure. Most functions are performed in real time so you do not have to exit

the OSD menu to see the results.

Please note: Available functions described may deviate slightly from actual OSD menu on your product.

This is due to different OSD software congurations and customized solutions.

Display / Picture / Brightness

Function only available in “Full” menu mode.

Increase/decrease the overall brightness of the panel electronically by controlling the voltage level.

This applies to the Main Source signal. Window overlays (PIP/PBP) and the OSD Menu overlay will be

unaffacted. This will be independent of the actual adjustment done by the front user controls like potmeters

or buttons.

● Level adjusts from 0-100 steps. 50 is default.

Display / Picture / Contrast

Function only available in “Full” menu mode.

Increase/decrease the overall contrast of the panel electronically by controlling the voltage level.

This applies to the Main Source signal. Window overlays (PIP/PBP) and the OSD Menu overlay will be

unaffacted. This will be independent of the actual adjustment done by the front user controls like potmeters

or buttons.

● Level adjusts from 0-100 steps. 50 is default.

Display / Picture / Phase

This function only apply for analog VGA/RGB signals.

Fine tune the data sampling position of the signal (impacts on image quality). This function will remove

small transparent defects in typical characters where a portion seems to be more faint then the nearby

black pixels. The faint pixels are always visible as a line from top to bottom (vertically).

● Level adjusts from 0-100 steps. Default is based on signal source.

Display / Picture / Frequency

This function only apply for analog VGA/RGB signals.

Adjust the horizontal frequency of the analog signal to improve visibility of the entire image. When it is ad-

justed, you will notice that the image will appear to be stretched and might in some situations start to icker/

scroll, at which point you must reverse the last adjustment to stop it from ickering/scrolling anymore. This

function can be used for older signals that is not automatically detected by the internal display

controller.

● Level adjusts from 0-200 steps. Default is based on signal source.

Display / Picture / Sharpness

Increase/decrease the overall image sharpness. This affects the whole panel, and applies to all signal

inputs and window overlays (PIP/PBP). Use it to increase the visual quality of signals from possible older

equipment or electronically weak signals.

● Level adjusts from 0-15 steps. 7 is default.