Manual

46
User Controls
IND100064-21
Display / Setup / OSD Settings / OSD Lock Mode / Normal - May be set as factory default
Function only available in “Full” menu mode.
Enables the user to enter OSD without any password protection. For Non-ECDIS Compliant usage.
● When selected, a box icon (
▀
) will indicate that the selected function has been activated.
Display / Setup / OSD Settings / OSD Lock Mode / Password Protect - May be set as factory default
Function only available in “Full” menu mode.
Enables a password protection before getting access to the OSD menu. Required for ECDIS Compliance.
● When selected, a box icon (
▀
) will indicate that the selected function has been activated.
When user now presses MENU, a requester will appear with 3 digits shown as:
0 0 0
To enter the OSD Menu, please change the 3 digits to:
3 2 1
and press the right (►) to
conrm. If you cut power to the product, the password protection will still be active and the same password
must be entered again to gain access.
Display / Setup / User Settings / DPMS
Enable/disable the DPMS (VESA Display Power Management Signaling) function. DPMS is a standard
from the VESA consortium for managing the power supply of display units for computers through the
graphics card e.g; shut off the unit after the computer has been unused for some time (idle) to save power.
Default is set to Enable (On).
● When selected, a box icon (
▀
) will indicate that the selected function has been activated.
Display / Setup / User Settings / Auto Source Select
Enable/disable the automatic detection and selection of any signal input and show it full screen. If you
have a external unit that switches between several other external signal inputs of different signal origins,
this function will be helpful and switch to the signal that appears to be valid since the last detection was
made. If for instance a Composite Video Signal was terminated, the display controller would automatically
scan the other available signal inputs and show that signal full screen instead. If that too is lost, it will
continue to scan the other signal inputs. If no signal inputs were in the end found to be valid, the unit would
eventually only show a black image and automatically power off (standby) due to inactivity (idle) in the
signal streams. Default is set to Disable (Off).
● When selected, a box icon (
▀
) will indicate that the selected function has been activated.
Display / Setup / User Settings / Filter - Only available in customized solutions.
Function only available in “Full” menu mode and when analog VGA/RGB signal are set as Main Source.
Enable/disable the ARGB lter (Analog RGB) which is a Signal Noise Reduction technique to enhance
a possible weak or bad RGB/VGA signal. It will remove certain types of noise patterns typically apparent
in close proximity of other electronic equipment with less or lack of proper shielding to prevent interference.
Default is set to Disable (Off).
● When selected, a box icon (
▀
) will indicate that the selected function has been activated.
OSD Menu Functions