A READ AND SAVE THESE INSTRUCTIONS FOR DOMESTIC COOKING 0 INSTALLER: Leave this manual with the homeowner. HOMEOWNER: Use and Care Information on Page If hood is to be installed Non-Dusted (Re circulation) , then purchase a set of (2) non-dusted charcoal filters from your local distributor or retailer and attach them to the motor. WARNING WARNING SUITABLE FOR USE IN HOUSEHOLD COOKING AREA. TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1.
This range hood is warranted to the original purchaser to be free of defects in material and workmanship for from the date of purchase. Our obligation shall be limited to the repair or replacement of a unit (at our discretion) that may prove, by our sole examination, to be defective under normal use and service during the warranty period. We may Issue credit In the amount of the Involve value of the defective product {or a percentage of It according to use) In lieu of repair or replacement.
TOOLS REQUIRED Measuring tape EET] Level Pencil Tape @ Polo screwdriver | o Arapaho U J Hammer Electric drill Safety gloves HARDWARE INCLUDED Part Description Quantity AA Hood bed mounting screws 6 BB Drywall anchor 6 ce Chimney mounting bracket screws 2 Utility knife Adjustable wrench Needle nose pliers Safety goggles SATSUMA 1375 Ebert Ave., San Francisco, CA 94124 Tol: 1-688-725-0989 Fax: 415-671-0839 E-mall: | Website: www GoTatsumakl.
PACKAGE CONTENTS cc o Pant Description Quantity A Range hood (Including filters and lamps) 1 B Damper (located with the outlet adapter) 1 Cc Chimney mounting bracket 1 D Bottom chimney 1 E Top chimney 1 ‘SATSUMA 1375 Ebert Ave., San Francisco, CA 94124 Tel: 1-883-725-0989 Fax: 415-671-0839 E-mall: | Website: www. GoTatsumak.
1 INSTALLATION DRILLING AND LINING 1 Draw a vertical line on the supporting wall up to the ceiling, oars high as practical, at the center of the area In which the hood will be installed. Draw a horizontal line at minimum 24 in. above the cooking surface. Place chimney mounting bracket (C) on the wall as shown about 1 in. from the ceiling or upper limit aligning the center (notch) with the vertical reference line. 25.4mmit In) 250mm(e.8 In) mea) ] Min. 809mm(24 In.
3 DUCT FIXING 4 CONNECTIONS DUSTED MODE oO Attach an adequate length round duct (not Included) on the top the outlet adapter. 1. Declines where the duct work {not Included) will un between the oO Check and properly tape all joints on duct work to ensure hood and the outside. proper connections. 2. Please be noted that a straight, short duct will allow the hood to perform more efficiently. 1. TELESCOPIC CHIMNEY ASSEMBLY 3.
NON-DUSTED MODE 1. Install the charcoal fitter (not included). 2. Please note that the williwaw flow out from the two grids on the two sides of the chimney top. Ne a” ELECTRICAL CONNECTION SATSUMA 1375 Ebert Ave., San Francisco, CA 94124 Tol: 1-688-725-0989 Fax: 415-671-0839 E-mall: | Website: www GoTatsumakl.
1 OPERATION OF CONTROLS Settings: LAMP SPEED PLUS SPEED MINUS 4ON/OFF REMOTE CONTROL RECEIVER add How to set the speed: Press the On/Off button (4) to activate the fan, then press the speed plus button (2) and speed minus button (3) to set the fan speed. Press the On/Off button (4) to tum off the fan and automatically memorize the previous setting at the next time of operation. This range hood can be switched to three speed settings.
STAINLESS STEEL GREASE BAFFLE FILTER oO The grease filters should be cleaned frequently (every two months of operation, or more frequently for heavy use). Use a warm detergent solution, oO Grease filters are washable. {1) PUSH DOWN (2) LIFT OUT 1. Remove the grease filters one by one by pushing down each handle. This will disengage the filter from the hood. Tilt the filter downward and remove. 2. Wash the filters, taking care not to bend them. Allow them to be dry before refitting. 3.
NON-DUSTED RE CIRCULATION CHARCOAL FILTER (NOT INCLUDED) o This charcoal filter (not included) is not washable, cannot be regenerated, and should be replaced approximately every 3 months of operation, or more frequently In the case of heavy usage. Remove the outer filters. The charcoal fitters {not included) must be applied to the suction unit In side the hood, centering them inside of it and turning them 90°until they snap inch place. Charcoal filter Put the outer filters back in place.
The range hood should be cleaned regularly internally and externally to preserve its appearance and performance. Clean the range hood periodically with hot, soapy water and a clean cotton cloth. Always clean in the direction of original polish lines. Always rinse well with clean water two or three times after cleaning. Wipe completely dry with a soft, non-abrasive cloth. After cleaning, you may polish with a non-abrasive stainless steel polish or cleaner. Always rub lightly and with the gran.
Problem Solution The range hood will not operate. oO Check that the power supply cable and all electrical wiring are properly connected. 0 Check that the power is muted on at the junction box or circuit breaker. 0 Check that the wiring between the switch board and the control board are connected properly. The range hood vibrates when the fan is operating. oO Check that the range hood has been secured properly to the wall or cabinet. Tighten it into position, if necessary.
HIGH KEY SWITCH MID Low d 3 2 STOP -© NOYES L BLACK GREEN PE N © WHITE MOTIVATE ova an NONE YELLOW WHITE BLUE Aq ABS 1 SATSUMA 1375 Ebert Ave., San Francisco, CA 94124 Tol: 1-688-725-0989 Fax: 415-671-0839 E-mall: | Website: www GoTatsumakl.
For & TA-588 ELECTRONIC SWITCH CONTROL PANEL YELLOW/ GREEN MOTOR LAMP POWER BLACK YELLOW WHITE BROWN GREEN ‘SATSUMA 1375 Ebert Ave., San Francisco, CA 94124 Tel: 1-883-725-0989 Fax: 415-671-0839 E-mall: | Website: www. GoTatsumak.