Instruction Manual

NON-DUCTED MODE
5 6
2. Please open the carton box and make sure
the foam under the wind wheel is take off
before install
Foam board
4.Mark the wall by following the mounng
hole to center the range hood. Drill the 2
mounng screws (AA) into the wall.
4.Mark the wall by following the mounng
hole to center the range hood. Drill the 2
mounng screws (AA) into the wall.
6. Aach and secure vent pipe to the adapter. Use
aluminum tape and wrap around the connecon
to make it air ght. Please note,to reduce the risk
of fire use metal ductwork.(Metal duct should be
purchased separately)
1. Carefully mark the range hood placement
on the wall.Range hood should be placed at
a distance of 24'' to 30'' or recommended by
local building code.
21mm
Holes on wall
5.Mount the range hood to the two mounng
screws that were installed in Step 4.
3.Aached the 6in. round adapter to the
outletand secure it using four screws
(BB) with gaskets (CC).
7. Aach the bracket to the inner duct cover and
secure by 2 screws (EE) onthe side. Carefully
insert both duct cover into the range hood.
8. Adjust to the desirable height by raising the
innerduct cover and secure the posion with
the bracket installed in Step 7 using the two
screws (DD) provided.
Recirculaon Mode
Cauon:Do not use plasc or rigid metal ducng.
1. Install the charcoal filter on.
2. Please note that the air will flow out from the
two grids on the two sides of the chimney top.