Installation Guide
Pairing:
1 Hold down the Lock button on the fob for 15 seconds (previously 5
seconds).
2 If the fob LED is ashing red/blue, the fob is already paired. Release
the lock button and do not proceed (see unpairing instructions if
necessary).
3 If the fob LED is ashing green:
a Press and release the HavenLock Admin button, then quickly press
and release the Lock button on the fob.
b Lights on both the HavenLock and fob should begin ashing white,
and the HavenLock will beep to show success in pairing.
Unpairing:
1 Hold down the Lock button for 15 seconds until the fob LED ashes
red/blue then release.
2 Within 5 seconds, press and hold the Unlock button for 10 seconds
until the LED light starts blinking white.
3 Within 5 seconds, while the fob light is blinking white, press and
release the Lock button one last time to unpair the fob.
Any key fob made before October 1 2019 will have a
dierent pair and unpair sequence.
Setting up the Generation 2 Key Fob
Control Panel (with cover lifted)
Key Fob
LED Status Indicator
Unlock Button Lock Button
Pairing Button
Visit havenlock.com for further troubleshooting and videos.
HavenLock, Inc. | havenlock.com