User's Manual
Need help? Contact us at support@havenlock.com
1
Charging
Plug the included charging cable (USB end) into the included power adapter. Open the HAVEN Control Panel
cover (C) and plug the charging cable into the Charging Port (D)
every 2.5 seconds when charging. Allow HAVEN to fully charge 6-8 hours before use. This is now a good
time to set up your Haven account at myhavenlock.com or on the HavenLock mobile app.
2
Cycling the Lock
Cycling the lock a minimum of 10 times prior to installation ensures that the nylon straps inside the lock are properly
stretched and calibrated. During shipment parts can settle and this cycling allows the parts to “stretch” and
(F) and lock
gate (E). Cycling the lock via the app a minimum of 5 times helps ensure the servo motor is properly engaged
and ready for use.
3
Include in Z-Wave Network
Push the reset button through the pinhole and see “Network Inclusion/Exculsion” in the Z-Wave section.
D
Charging Port
B
Pairing Button
Control Panel (with cover lifted)
R
Reset Button (use pin)
C
Control Panel Cover
A Status Indicator LED
E
Locking Gate
F
Manual Foot Locking Pedal
PREPARING YOUR HAVEN CONNECT Z
5 HAVEN CONNECT Z