1996-2006 Ford Taurus Install Instructions

INSTALL INSTRUCTIONS C-TCB-10

1996-2006 FORD TAURUS

TOOLS REQUIRED:

3/16” Allen wrench

3/8” Standard Socket Set

3/8” Metric Socket Set

3/8” Ratcheting Wrench

Powered drill w/ drill bit set

Standard Open-end wrench set

HARDWARE:

QTY DESCRIPTION PART #

1 Pole support assembly CM93071-10

1 Telescoping pole CM93072-1

1 Under floor plate CM93132

1 Lateral support brace CM93148

1 Side support brace CM93149

2 ¼-20 Nylock nut GSM30016

1 5/16-18 Nylock nut GSM30017

2 3/8-16 Nylock nut GSM30018

4 ¼” Flat washer GSM31005

1 5/16” Flat washer GSM31006

5 3/8” Flat washer GSM31007

2 ¼-20 x ¾” Hex head bolt GSM33001

2 3/8-16 x ¾” Hex head bolt GSM33027

1 3/8-16 x 1 ¼” Hex head bolt GSM33029

Always!

 Read all instructions before installing any Havis-Shields Equipment Corp products.

 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

 Use hardware provided with install kit

SUB ASSEMBLY:

1. Confirm receipt of all hardware and components.

2. Remove front passenger seat base trim.

INSTALLATION:

1. MOUNT POLE SUPPORT ASSEMBLY:

• Align pole support assembly’s slotted hole with similar slot on seat base and loosely

attach using 3/8-16 x ¾” bolt, washer and nut.

• Loosely attach smaller slot on assembly to seat base using ¼-20 x ¾”

• Repeat these processes attaching the side support brace to passenger seat base.

• Now loosely attach the side support brace and lateral (forward) support base to pole

assembly using 5/16” Nylock nut.

PAGE 1
INSTALL INSTRUCTIONS C-TCB-10 1996-2006 FORD TAURUS TOOLS REQUIRED: 3/16” Allen wrench 3/8” Standard Socket Set 3/8” Metric Socket Set 3/8” Ratcheting Wrench Powered drill w/ drill bit set Standard Open-end wrench set HARDWARE: QTY DESCRIPTION 1 Pole support assembly 1 Telescoping pole 1 Under floor plate 1 Lateral support brace 1 Side support brace 2 ¼-20 Nylock nut 1 5/16-18 Nylock nut 2 3/8-16 Nylock nut 4 ¼” Flat washer 1 5/16” Flat washer 5 3/8” Flat washer 2 ¼-20 x ¾” Hex head bolt 2 3/8-16 x ¾” Hex
PAGE 2
Note: When mounting side support brace to floor of vehicle, be sure to check for obstructions prior to drilling or lag bolting to floor. • • • • With lateral support brace flat to floor of vehicle, mark and drill 3/8” hole. Align under floor plate with hole in floor and thread 3/8-16”x 1 ¼” bolt and washer. Tighten all hardware being sure that pole support assembly remains level and upright.