1996-2008 Crown Victoria Driver and Passenger - Trunk Side Mounts Install Instructions

C-TSM-CV-P_INST_4-08

INSTALL INSTRUCTIONS

C-TSM-CV-D and C-TSM-CV-P

1996-2008 CROWN VICTORIA

DRIVER and PASSENGER - TRUNK SIDE MOUNTS

• Drill with 1/8” and 3/16” drill bits

• Open End Wrench - 3/8”

• Phillips Screwdriver

TOOLS REQUIRED:

QTY: DESCRIPTION: PART #:

3 10/32 X 1/2” Machine Screw GSM33118

3 10/32 Keps Nut GSM30028

3 #10 x 3/4” Sheet Metal Screw GSM33195

HARDWARE:

Always!

• Read all instructions before installing any Havis-Shields Equipment Corp products.

• Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

• Use hardware provided with install kit

• For product support: visit the Install Instructions Section of our website at

http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-800-524-9900.

LINE DRAWING:

Passenger Side shown

# C-TSM-CV-P

PAGE 1
INSTALL INSTRUCTIONS C-TSM-CV-D and C-TSM-CV-P 1996-2008 CROWN VICTORIA DRIVER and PASSENGER - TRUNK SIDE MOUNTS TOOLS REQUIRED: • Drill with 1/8” and 3/16” drill bits • Open End Wrench - 3/8” • Phillips Screwdriver HARDWARE: QTY: 3 3 3 DESCRIPTION: 10/32 X 1/2” Machine Screw 10/32 Keps Nut #10 x 3/4” Sheet Metal Screw PART #: GSM33118 GSM30028 GSM33195 LINE DRAWING: Passenger Side shown # C-TSM-CV-P Always! • Read all instructions before installing any Havis-Shields Equipment Corp products.
PAGE 2
Installation: Position frame assembly as shown. Trunk liner does not have to be removed, but you may want to cut it as needed to improve access for routing wires. Bottom frame mount attaches to the trunk side ﬂoor. Drill three pilot holes with a 1/8” (.125”) drill bit. * Always check under ﬂoor before drilling * Attach bottom frame with three (3) - # 10 x 3/4” sheet metal screws. Top frame mount attachs to the trunk gasket mounting ﬂange. Drill three holes with a 3/16” (.187”) drill bit.