User Guide

C-TCB-26_INST_9-07

INSTALL INSTRUCTIONS C-TCB-26

2002-2008 FORD EXPLORER

TOOLS REQUIRED:

Torx Bit Set (T-55)

3/16” Allen wrench

3/8” Standard Socket Set

3/8” Metric Socket Set

3/8” Ratcheting Wrench

Powered drill

3/16” & 5/16” Drill bits

Open-end wrench set

HARDWARE:

QTY DESCRIPTION PART #

1 Pole support assembly CM93071-26W

1 Telescoping pole assembly CM93072-1

1 Side support brace CM93135

1 5/16” Nylock nut GSM30017

2 5/16” Flat washer GSM31006

1 5/16-18 x 1” Hex head bolt GSM33012

2 ¼” x ¾” Hex head lag bolt GSM33060-1

Always!

 Read all instructions before installing any Havis-Shields Equipment Corp products.

 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

 Use hardware provided with install kit

Location of factory

seat bolts

Side support

brace

Pole support

assembly

Telescoping

pole assembly

PAGE 1
INSTALL INSTRUCTIONS C-TCB-26 2002-2008 FORD EXPLORER TOOLS REQUIRED: Torx Bit Set (T-55) 3/16” Allen wrench 3/8” Standard Socket Set 3/8” Metric Socket Set 3/8” Ratcheting Wrench Powered drill 3/16” & 5/16” Drill bits Open-end wrench set HARDWARE: QTY DESCRIPTION 1 Pole support assembly 1 Telescoping pole assembly 1 Side support brace 1 5/16” Nylock nut 2 5/16” Flat washer 1 5/16-18 x 1” Hex head bolt 2 ¼” x ¾” Hex head lag bolt PART # CM93071-26W CM93072-1 CM93135 GSM30017 GSM31006 GSM33012 GSM33060-1
PAGE 2
SUB ASSEMBLY: 1. Confirm receipt of all hardware and components. 2. Remove front inner and outer passenger seat bolts on vehicle. INSTALLATION: 1. MOUNT TELESCOPING COMPUTER BASE: • Position pole support assembly on top of passenger seat base mount and align holes in pole support assembly with holes in seat base. • Loosely attached factory seat bolts that were removed during subassembly.